Recent content by Omagunagitya

I just replaced the Neutral Safety Switch (Transmission Range Sensor) on my '05 SR5 and had the same struggles as a lot of people here in removing the old one. A good piece of advice that I wanted to share was to sand the rectangular post using a Dremel (barrel-shaped sander bit) BEFORE...

Driver's Window not functional (not even a sound). I've spent 2 weeks researching/disassembling/reassembling the doors on my 4Runner. I've replaced the driver's door window switch and the driver's door window motor with no change. I jumped the motor with the car battery at the connector and the...

Well, It's fixed. In case any of you go through the same nightmare I did, don't go to the stealership. It turns out that the Tailgate Lock Actuator Assembly was malfunctioning and needed to be replaced. I also must have fried the Window Motor when I plugged in the power supply. I replaced the...

Thanks for the ideas JrAdRock. I probed both wires at the blue connector with the ignition off. The Blue wire had 12 volts, but the blue/red wire had less than 1 volt (but not zero). I probed the blue/red wire in the top left of the hatch - as you suggested - and found that it had 12 volts at...

2005 SR5 Tailgate Lockdown For about a year, I was having a similar problem with the tailgate as JrAdrock80 described. After disconnecting the battery to replace the stereo I lost wiper/defrost/latch/lock controls. At that time the window would still go up and down, but I needed to reset the...

ZombH8R, Was the brake in the stem for your speedo visible? I recently changed my gauge cluster from black to white and when I put the needles back I snapped the fuel gauge stem below the surface. My fear in gluing it is that it'll never spin again. I'm curious if you had to push the back half...