Recent content by oneten

Did you ever figure out where this was coming from? Having same thing.

Currently running Bilstein 5100s on stock springs, looking to get to about 3" lift on the front, 2"+ on the back. No winch or extra weight on the front. Tire carrier on the back, no full bumper. Can you recommend which springs to order? Looking for red.

Yeah, I had a 17x8.5 with a 0 offset on 285/70 and had no rub except turning over bumps. Sounds like a couple others did it with -38mm but I def had less than 1" with my wheel turned between the tire and BM.

I have 2.75 front and 2 in rear and no way I could have fit 285/70s + -38 offset and driven without BMC. I had 285/70s on a much smaller rim and it was almost touching the BM.

That was just install. Went back to do some upgrades a few months ago but they refused to mount my new 285 KO2s, purchased through them, so cancelled the order. Ended up getting discounttire to match and had teamxtreme in rolesville do the work. Got me in quick and did solid work, shop guys...

Had my 285 load C installed for about 3k miles but always get a vibrate/wobble around 60mph. Road force balancing hasn’t fixed, alignment has been done. Anyone experienced this?

I went from 275e to 285c about 1000 miles ago and running almost exact same mpg. Feels a little more sluggish to me as well.

I ran the same setup on SR5 and only had to trim front bumper but YMMV.

Moving from 275 E to 285 C Not sure if it's been discussed but has anyone gone from the 275 E to the 285 C? Not sure what to expect as far as MPG change since the 285 C is lighter weight. I expect acceleration to slow but would almost make sense moving from 275 E to 285 C would improve MPG?

I don't have any great pictures but hope these help. There's also quite a few people who stacked 2 10mm OME spacers but didn't look high enough to me: http://www.toyota-4runner.org/5th-gen-t4rs/177855-5100s-1-75-stacked-10mm-ome-spacers-back.html

It will be very close to level. Any weight in back and probably will sag. I did 1.75" 5100s up front with 1" cornfed in back and it has decent rake.

Am I understanding correctly, you're referring to this piece? GARNISH FR BUMPER | Genuine Toyota | PZ323-35056 Can you point to where to get it for $165?

OP, any pics of this setup? Contemplating doing this weekend.

Just FYI but 4wheel on Glenwood quoted me $650 for 5100s all around with rear cornfed spacer and alignment for my 5th gen.

BP has a nice one but it seems to have disappeared from the site. Might need to contact directly. Bullet Proof Fabricating