Recent content by OrangeChicken123

i think its the u-joints on your driveshaft... i felt vibrations when i let go of the gas tho. Try greasing the u joints, and if you take the drive shaft off make sure to mark the drive shaft so it goes in the exact same way it came out. If that doesn't help, you probably have to replace the...

i disconnected my ubj from the uca and took the whole spindle out before cutting mine. taking the spindle out with the ubj just makes life a whole lot easier

figured it out! bottle jack under the outer tie rod pushing up.. Thanks for trying to help, appreciate it.

i tried using an open end while holden onto the stud with pliers but the castle nut isn't deep enough for me to do that, if thats what you meant.

just replaced my inner tie rods... everything was fine until i tried to bolt on the outer tie rod, problem: the stud on the outer tie rod keeps on spinning as i am trying to tighten. Any solutions?

LOL :bravo:

UCA's should come with all that stuff and from what i've read SPC light racing ucas are really popular HERE $400 for ucas then maybe $100 for labor to take out your ubj then put in the metal bushing thingy that comes with the spc's, to save some money you should at least attempt to take the ubj...

alright cool! and thanks!

have you had any problems?

Hey guys! Is the space between the metal insert and the ball joint boot normal or no? is doesn't look right to me ^^

Hey guys! Is the space between the metal insert and the ball joint boot normal or no? is doesn't look right to me.

alright guys, i have literally tried everything!! including Doc2012 idea. My hands are literally black, bruised and bleeding. I think I'm going to have to tap out and take it to a shop. Anyone have a link to a write up on how to take the spindle out??? LMAO! i thought i was going to get...

elaborate? like a slit above the lip horizontally? or ON the lip halfway from where iam staring at it?

yes. i'd prefer not to grind anything, but it seems like there is no other choice.

and it just fell out? how long did you hammer for?