Recent content by outkast14

I see that. Does anyone have them installed on a lifted runner on 285's? If so can you post a pic.

Looking to get a side step for the SR5 and was wondering if any has taken off the rocker cover and bolted up a set of N-Fab's. I'm wondering how it would look without the extra rocker panel delete kit. If anybody has some suggestions lmk. Or will the newer trail steps bolt on also? Total newb...

I would contact your insurance comp. A lot of times stuff like that can be covered under comprehensive. Sometimes you can get them to write you a check and if you wanna plasti dip the insurance check should more than cover that. Good Luck

For the drive there. Have some ideas in my head that would take some fab work but wasn't sure if there was something already out there that was already working.

I've got a 4th gen with a Rola extended roof rack and I'm looking for rod holder ideas for and upcoming trout fishing trip. If anyone has any ideas or has done something similar any help would be appreciated.

I'm looking for a full length rack that I can still use the factory roof rails with. I have an 04 Limited V8 4wd with the painted rails and would like to keep them if at all possible. Does anyone know of someone that makes a rack that will fit and utilize the factory crossbar mounting slide ins...

Sounds like your problem is the air mix motor or blend door motor. Different manufacturers use different terms. It closes off the air from blowing over the hot coolant in the heater core. If that motor is inop it will cause that door to get stuck open or closed therefore either causing no heat...

Thanks. I'll check it out. At least its cheaper than a steering rack.

Add a GOBI rack and your done.

So I recently bought a 04 Limited V8 4wd and its from Ohio. So its rocking a little rust....to say the least. Recently when driving it I notice an issue with the steering. When driving it straight for a good amount of time and then you go to make a left or right turn it is stiff and it does it...

Sounds like its more of rotational issue to me. I would def take it somewhere for a second opinion.

Sounds like you more than likely overcharged the system.

Just here for the show.....:popcorn:

Willing to meet this week... Would love to take this stuff off your hands for you if its still available. Please lmk if its already gone.

Pm sent. Hope you still have it.