Recent content by PaulSula

I am no longer using my stock turn signals or fog lamps. If someone needs to replace there's or wants a replacement I'm your man. $100.00 shipped in CONUS. Thanks.

The heaters stunk or your seat covers? Or the seat covers after you used the seat heaters?

Called them last week. They said that if anything went wrong with them that they would send out a new heater. Sounds like a great warranty to me!

Anyone have any experience with the Wet Okole seat heaters? I am thinking about getting some when I order my seat covers. Thanks in advance!

Yep, not from NM but currently stationed here. There's some pretty sweet trails and mountains to check out. Make sure to check out the Ruidoso Ridge Runners group. Just google their name. Welcome!

Gear Advice Alright guys, I am setting my sight down the road on my next upgrade. I think it's going to be gears and lockers, however I know little to nothing about re-gearing our T4Rs. I would like to get a gear ratio that would put me ahead of the power curve with my larger sized (33")...

Thanks for all the advice. Now, I'm working to wear out these tires so I can get the new ones.

It seems like no one can think of a reason not to mount the 305's on a 7.5" rim. I'll do it! (Eventually) Thanks for the help fellas.

Richard, thanks for the reply. Is that against the tire manfacturer's guidance? How long have you run this set up? How about on-road / off-road manners? Do you get a lot of sway from mounting a large tire on a small rim? Does anyone else care to weigh in on the subject?

I am starting to do research for some new tires. I know that my stock 16" rims are only 7.5" wide. I could fit a 285/75/16 BFG KM2 because the minimum rim width according to BFG is 7.5" HOWEVER...what I want to find out is about 305/70/16s. BFG says that the minimum wheel width is 8". A...

Yes, by sagging I mean the stock suspension. I wouldn't think that the aluminum and high strength polymer that the good folks at CornFed use would compress, however whenever you take that stock coil over and induce all that extra material, it didn't surprise me that it would eventually take a toll.

Thanks drifter, I really like it...too bad I couldn't convince the wife to jump into the photo for ya'll!

Got to flex out my ToyTec lift today, very happy!

From what I've read, the plast-dip won't hold up off road so it's a no go for me. I have a buddy that is building a workshop that will include the ability to powder coat wheels. My plan is to keep my wheels but powder coat them black. Won't be done till the winter though. Thanks man.

Yep, removed about 200lbs of junk from the shop after I took the picture. The front and rear were each measured to 39" from ground to wheel well. Good Eye!