Recent content by pcleary1210

Put it up for sale :moping: http://www.toyota-4runner.org/sale-vehicles/208000-fs-96-4runner-manual-lifted-factory-locker.html

Selling my 96 4runner. It's been a great rig but I need a tow vehicle for racecar, so this one has to go :( There body isn't perfect (see pics), the inside is pretty good but not perfect either. 225k but it's an ultra reliable, and a rare 5-speed truck with a factory locker. It's got a 3" rear...

I need the pigtail that connects to the a/c compressor's plug. It's a single-wire plug that comes from the upper timing cover on the right-hand side.

Someone on here recommended midgrade or premium due to the ISR Mod and Deckplate mod. I didn't mind so that's what I was doing. I've since gone back to basic (which was probably another mistake). -PC

Hey Fellas, Sorry about the late response. I have a Denso on order. Going to try to return the other O2 sensor (not holding my breath). Air filter will go back to standard Wix Filter, old one was just fine anyway. Also going to replace the fuel filter and seafoam hell out of it. Lastly...

I'm going to try to skip making everyone read a lot of BS. Here's the skinny: *NOx was gross polluter. HC's were a little bit high. CO was very good. *225k, not the factory cat. *Just installed a new bosch upstream O2 sensor, NGK plugs, K&N Air filter, oil/oil filter *Sprayed out the MAF w/...

The back end of my 3rd gen 4runner has been crunched in for a while now. The rear bumper needs to be removed (the corner is crushed inward), the body needs to be hammered out on the passenger side, and a new bumper installed. It'll never be perfect, though, and with that said I was wondering...

I have a very small need. I need one of the little hand-bolt thingies that tightens down the roof rail. Someone stole one of mine and I've had to use bailing wire to keep it from flopping all over the place in the meantime. -PC

You're very obviously not from California, and thus not familiar w/ how stupid our laws are :(

They have to do a visual inspection. And Yes, ISR Mod. I'm guessing they'll fail me right out of the gate for having PVC caps and vacuum fittings where the other items should be. I need to find a smog guy that might be willing to overlook such an issue.

So I took the expansion chambers off of my intake and replaced w/ PVC Caps as I'm sure many have done. ......then I moved. Now it's smog time and I have NO IDEA where the little bastards went. Can anyone w/ a third gen loan me theirs for a few hours? I just need to go smog, and then will bring...

These aren't interference motors. A botched timing belt wont destroy the engine unless there's something else going on here....

Any fender flares?

PM'ing about rear bumper, panhard bar, misc trim. -PC

.......oh. :(