Recent content by Pintlar Tactical

Guess I missed the point?

This is a new problem. He has had it for about 5 years. With the center diff lock off he cannot find any gear or even put it in park. Trying to put it in reverse or 4D causes loud clunking noises. With the center diff lock engaged everything sounds and feels normal. Also, I am pretty sure...

So I am a 3rd gen owner but my brother has a 2004 4.7 V8 4wd and experienced the following: 1. All was good until we parked to air up. He tried to put it into 4WD DRIVE and all you heard was clanking and clunking. 2. He could not put it back into park or find any gear. 3. Press the center...

I have a Smittybilt XRC 9500 Comp in my ARB bumper. Solenoid box is mounted under the hood on the passenger side wheel well.

The seal depth is set at 5.5mm as specified.

Have a oil leak on the passenger side where the CV goes into the stub shaft. Have replaced the seals 3 times and it is clean for about 20 miles and starts leaking again. This happens on 2 different CV’s (both new). When I rebuilt the front diff the only thing I didn’t do was replace that...

I am very informed on FI and already plan either a 7th Injector setup or..... Just wondering how the Magnusen kit is setup and if anyone had any install issues. I am 220k 2001 with spot on compression across all 6 cylinder and no oil loss. Just thinking with all the steel I have installed and...

Install Instructions? Just got my rear bumper but no installation instructions. Anyone have a copy? Could not find on their website.

Thanks folks - I think it is the 156 Dark Gray Metallic after comparing it to a 1998 or 1999 (not sure what the year was). I might go a different route and find something close in a powder coat color, then PC my wheels and get a can of the same color to repaint the bezel.

I actually want to replace it with leather. The driver side bolsters on the cushion and seat back are pretty much toast. I will either have to replace them or have an upholstery shop rebuild them.

I searched the forums and could not find confirmation of the paint code. I am thinking it is the same as the 1998 Dark Grey Metallic (paint code 156). Does anyone know the actual code or can confirm my thought on it being 156? Thanks ind advance for any input - William

I guess that is very possible. I actually prefer the original 16" wheels better than these ones but not so much that I would spend money replacing them. I may just PC them a slightly darker color.

Put an e-locker in it and you would probably be OK for 80% of what you might get into on the islands.

Thanks Monty for confirming. I saw that but was unsure if there may have been some other wheels that possibly made it on the T4Rs. Still a little dumb-founded how these ended up on this truck unless the dealership put them on it for some reason.

Yep - they are 16's. A bit strange as I purchased the truck from the original owners, older couple that I am pretty sure would not have swapped wheels. No accidents and I have a 2" thick pile of dealer maintenance records that go back to its first oil change. Wonder how it ended up with those...