Recent content by plumcrazy

These were the labels attached to each coil. Notice the A and B on the right side or the labels. I couldn't notice one taller than the other just looking at them. The tech I talked to at ARB did mention that A could be stiffer than B possibly. Sent from my iPad using Tapatalk

Thanks for the replies. As is usually the case, you guys are very informed and useful. After speaking to ARB tech, they essentially said the same thing. Use the A labeled longer spring on the heavier side of vehicle. In my case, the drivers side because of fuel tank, driver, ect. He also...

The A coil is slightly taller. My confusion started when checking to see if it was obvious to use A left and B right. Some said to use taller on right rear side to offset taller left front springs. Some said ARE suggested this because of engine torque wrap on the body. Didn't know I was driving...

Need input on install. 2001 all factory 4WD. Ever so slight driver side lean. Installing tundra coils up front and OME 906 in rear with 5100s all around for a slight lift. Noticed the 906 coils are labeled A and B. To those that have installed these, which coil did you use on which side? I...

Speaking of going around the sunroof. Has anyone installed tracks along side the sunroof? I need tracks as far forward as possible and do not want to use the crossbars that clamp between the roof and top of door. Yakima makes 60in tracks, but that isn't long enough to replace the current...

Ordered and received a couple wrenches. Tekton 1/2in 10-150ft/lbs. Nice with no complaints. CDI 3/8in 20-150in/lb. Even nicer with no complaints. Thanks for the recommendations.

Probably so. I'll start a GoFundMe page and we can all pitch in a buck so he can get his deserved discount.

The rush of orders definitely tripped the sales meter to alert an issue I'm sure. Still appreciate the gesture. Torque wrench shows to be at my local PO for tomorrow delivery. Probably a box of rocks with a nice FU note. I took a pic with my phone when I ordered Sent from my iPad...

Just received email from Amazon stating my order was canceled due to " technical problem "

Must have been just in front of you. Said 8 left when I placed my order. Didn't need the wires at this point, but will use the plastic wire separating clips since I broke a few on a previous repair. Don't think they sell those separate and no way I could have rounded those up for this price...

Recently found myself in the exact situation you are in with disposal. None of the local stores would take it. I even checked with radiator shops. They said they do not take it because they are now charged for having their tanks emptied. I got lucky with about 8 gallons when a guy needed...

This was my experience as well. 3rd gen 4Runners must be the new YETI in Colorado. I was recently looking for a 3rd gen for our son's first vehicle and several potential vehicles popped up in the Kansas City area. Many that I inquired about were snatched up quickly by people from Colorado due...

Agree also. I recently replaced my tensioner only because it came in the kit I purchased and I was under the impression everything needed changing once you were that far into belt replacement. Surprisingly, most parts I replaced seemed to be in good working order. Next timing belt job, I'll do...

Had no idea you guys had only been on YouTube for one year. Never looked at dates and just figured the videos were years in the making. Great work. Congratulations. You've been a great help to myself and many others.

Recently removed mine and it was torqued on tight enough to start bending the bolts that came with the specific pulley holding tool. Finally convinced myself to do the starter bump trick - should have done that to begin with. The tool was strong enough to hold pulley for reassembly. Do the...