Recent content by rorikk

No worries! I ended up going with them also! I did it DIY and dropped them into some spare 99 housings I got from a buddy. A bit of a process but a fun learning experience. Wiring them was super easy like you said. Just hooked up the rear halos and still need to wire up the ambers. Loving the...

What HID setup is this and what halo option? How is it wired up? I’m about to pull the trigger on an HID retrofit and can’t decide if I want halos. These look sweet though!

I used to love reading so much back in the day, all into fiction and stuff like that. Hadn’t gotten into any good books for a few years. But, this year and this month...I’ve been reading non-stop, well listening and reading since I’m doing a lot of testing and assembly at work. My buddies got...

UPDATE: Might have been solved by IAC cleaning! UPDATE: After testing my way home last night and way back into work this morning trying to recreate the warm starts after half hour of driving, I haven’t seemed to have an issue whether 5, 10, or 15 minutes after shutting off. Soooo...looks like...

The car runs fine no problem on a cold start and as long as you want to drive it. It only has issues on the warm start. It’s not that it’s hotter and hotter that makes the issue. If I start up a minute after shutting off it’ll stay, but maybe at 500rpm, but waiting 2 or 3 minutes after shutting...

Thanks for the input. I’ve checked for vacuum leaks, but I’ll keep an eye out. Where would be the grounds I’m looking for? The EFI fuse I got 93ohms, not beeping and showing continuity. I’m going to check when it’s cold/sitting all day to see if there’s any difference. But I may swap one...

Ok! That’s on my list. I’ve got a fuel filter on hand that I should get to by this weekend. Curious how that stops things up when warm, maybe it just settles and then won’t go? The IAC checks out electrically and I replaced it with a brand new one two years back. That looked much better than...

Thanks so much for throwing that out there. I had cleaned the throttle body a few weeks back without really removing it. I went for the IAC last night, unbolted it from the throttle body, sprayed and cleaned it up(although it looked really clean having replaced it two years back) and put it all...

Hello all, I have been browsing around the forum for a ton of info the last few years and it's been so helpful! Lately though, the other posts haven't quite had my specific problem. I am working through the fixes they used to try and isolate the issue. I have been chasing an issue on my...

Spotted super clean 1st gen with a Hilux rear hatch? Nice blue color on my commute into work today. Hwy 101 S from Ventura. Sent from my iPhone using Tapatalk

Looking to buy a 3rd gen SR5 16in OEM wheel to use as a rotating spare for my rig. Looks like this And my current rims here: Sent from my iPhone using Tapatalk

Cool, I’ll probably snag some parts to make that swap then too. Is the slave cylinder just nice insurance to swap then too? Easier to get at? Been reading to do master and slave at the same time if Master is going. Good to know about the flexplates, hadn’t gotten quite that deep into...

Also going at the clutch and looking for other parts to replace. Anything else you found that was worth replacing while the trans is out and swapping the clutch? Going at it in a few weeks here and doing my best to have all parts on hand to make it the smoothest I can. Thanks!

So sweet you got a 2nd, 3rd, 4th, and 5th gen out there! Sent from my iPhone using Tapatalk

What bumper is this? I really like the look and stance of it! Sent from my iPhone using Tapatalk