Recent content by Runnah

7th has been on there and working for years. All wired up correctly. Left message for Gadget at URD to see if unit can be repaired or not. We’ll see. I put it back in sequence to double check by reproducing issue and it did. As the problem frequency continued to increase over the last month...

Hey 4reak thanks for the response. So I just took the URD module out of the chain. I have one of those million wire bridges so I plugged my stock plugs directly into my ECU and problem solved. So URD module has some issue. I swear the rig drives better now using stock ECU. Thanks again

So no one has anything for me? How about this. What if I bypass the URD module and just run on my ECU to determine if the fault with the CPS is from the ECU. I figure I’ll be running lean but will it be ok to drive for 5 mins to see if I stall or not? That way I can rule in or rule out the ECU...

Hey all. I have 1996 T4R 3.4L M/T with 1st gen S/C and URD 7th. Having problems with ignition loss. Just dies with tach to zero. If in flight and in gear I just turn key off and back on and I'm back in business. If it shuts down when stopped I have to turn key to off position prior to...

Hey thanks for reply and info. Truly appreciated. RESISTANCE AT ECU WIRING CONNECTOR (DISCONNECT WIRING CONNECTOR) NE -E2 : 140-180 OHMS So I tested continuity along harness between CPS plug and ECU plug(E7 pins 6 and 12) and had continuity. Then tested resistance and came up with 1.7 ohms...

Hey hate to resurrect and jump this thread all at once but I can’t start a new thread because although I’ve been a member for a while I don’t post much. So I have a 1996 T4R 3.4L M/T with a 1st gen S/C and URD 7th injector. It’s been stalling out for last two months. First once in a while...

Hey I know there is info out there on rebuilding the gray 1st gen S/C especially by chris360hawks. But I was wondering about replacing bearings and seals in rotor plate. I've read that it is very difficult and requires extreme tolerances on realigning the rotors. How does one make sure that the...

Resurrection time. I can't start a new thread as I am a noob. I've been lurking for a couple of years though as I own an 03 Extcab Taco 3.4 m/t and ever since have wanted a t4r. That red coolant got in my blood. So now I just picked up a 96 SC 3.4 m/t with suspension mods that are pretty sweet...

I know it's an ooold thread but... I have a 1996 4WD 6cyl with desert dune metallic (1A5). I am looking to swaps some doors and fenders and hood off a 1998 2WD 4cyl. The issue I am concerned with is that on a vin search on the Toyota owner spec page mine has on the "factory installed equipment"...