Recent content by ruskymx

Yes they are.

Here are some more pics as requested. The PS rear tire is on top of some wood so it looks tilted. I did notice that the axle is not centered L to R in the front. It looks like the person that welded the spring perches onto this axle didn't measure properly. They will need to be adjusted...

Here's mine and the stages it's been through. How I bought it. IFS Lift and 33's SAS! Ruskymx P.S. - Time to update the signature!

I don't think these will fit a 3rd gen. This is the 8" rear and the 7.5" front. The 3rd gens are 8.4" I think. I noticed the thread title said 86-96, but was supposed to be 86-95. Sorry for any confusion. It should be fixed now. Ruskymx EDIT: Damn, just noticed you were from Philly too...

FS: 86-95 IFS 4.88 & Rear diff plus more I finally got my 4Runner SAS'd and I have the IFS parts to sell. Most of the parts were new as of July of 2010. They may have 3-4k miles on them and 4-5 offroading trips. All items are located in Orwigsburg, PA. All Prices are Plus shipping. Paypal...

So far I like them. I can't complain about anything. They are not very noisy on the road and clean out well on the trail. I'm debating about going to 35's or wearing out the 33's first. Ruskymx

I went to pick it up today and they were bleeding the brakes when I got there. They couldn't get a good pedal and we finally noticed one of the lines going into the LSPV in the rear was leaking so they had to replace the line and bend one up to fit. I'll be picking it up over the weekend or...

Photo Update: 3" TG Kit 4" TG Rear Leaf Swap They were getting it on it's own weight today and flexing it out to make sure everything is OK before final welding. I should be able to pick it up of Friday. They did run into a snag though. My 4Runner has the G58 transmission. :bash: So...

SAS incoming! November 4th it goes in for surgery. Dual cases, 5.29's, Aussie lockers front and rear, trail gear 3" hd springs , 4" rear leaf swap

The dome light is sold and the front speakers. I do have both speaker housings and the front passenger side running board end cap. I do not have the little rubber strip. That part was sold as well. If you are interest in what I have, let me know and I can send you a quote with shipping...

Yes, I'm selling the parts of the running boards since the rest of the boards are rusted pretty bad. Let me figure out which one it is and get you a quote. Anyone else waiting for quotes etc from me will hear from me tomorrow, Wednesday the 28th. I am off work and can get some stuff...

If you are referring to the end caps, then yes. Ruskymx

The O2 sensor is still attached to the exhaust. The studs/nuts are probably going to need to be cut off because they are very rusted. Are you looking for the metal shell that houses the sensor? I think I may still have the rubber strips, but I have to check and see to be sure. My garage is...

I do have the DS front, but the part with the clip broke off. I do have the piece that broke off though with the clip Here's a pic. I do have the spoiler yet as well. I need to find a box to fit them in so I can get you a quote. I may be able to make one from a bigger box I have here...

Sorry, thought I responded about that already. Are you referring to the one that's somewhere under the dash by the blower motor? A picture would be helpfull if you have one of the part you are looking for. Thanks, Ruskymx