Recent content by SaulG

Bulb holders making contact with circuit board? Broken contact at connector? May have to pin check power.

Small amount of grease on stop buttress works well, and makes them last longer.

Yes if you want it to seal. Small propane, map gas torch works well.

ABS system accumulator will be fed by energized pump. Did you perform ABS bleed?

What did cylinder 3 spark plug look like? Leak usually steam cleans cylinder, plug, valves. Might be small leak overnight (no cyl pressure). That clears once running.

Having never needed a Timmy video I am unaware of the fascination. There are quite a few videos produced I've heard he's ripped off.. so, with an FSM available and 40+ years of Lexus/Toyota experience....never a fan of his B.S. Good Luck to those that are.

Yes you are..

You best ask the almighty Tim the Tool...he's done a whole fifteen!

Toyota Hilux Pick Up 4 generation 11.1983 - 08.1988 Toyota Hilux Surf (4runner) 1 generation 05.1984 - 04.1989 68610-89102 also some cars JDM. maybe try an overseas distributor ?? Late 80's early 90's corolla..hmmm . Lucky you.. Looking for two complete doors both Right W/vent

If you have all the broken parts..a "fix" is to insert a straw from spray can (cut to fit) and super glue it back together, it works.! Or shop 90925-05047 iirc? is for the TVV 50~108 $$.

OMG no one in their right mind would pull cams to do valve adjustment! The best tool is the Toyota SST 09248-55040 (09248-05410, 09248-05420) grab a pocket screwdriver and a telescoping magnet.. maybe a pick as well. Worst part is getting shims from the dealer. Doesn't Tim the Tool have 50...

Far from totaled. Take it home and fix it!

Always use Landcruiser switches for that o.e.m. look.

C27 connector looks to be interior lighting feeds, exterior and headlamps..?

Take it by any O'apazone and have battery checked with a load tester, not a DVM. Second opinion an all . . .