Recent content by SdayRiverRunner

Couldn't find any notes i made. Sorry i can't be of more help short of taking my dash apart again. Good luck.

It was over two years ago and i suffer from CRS (Can't remember $#/!) so i'm not sure how i wired it. I'll look around when I get home. I may have traced it with the help of a volt/continuity meter.

I used the SWI-PAC from Crutchfield. It gives you control over volume, change the songs from the Ipod or change the source. It uses the 4 pin plug. You have to cut it off and direct wire it.

Swapped mine out right after i bought it. AFAIK the harness is unique to the UrbanRunner. I had to cut the plug off the the wiring harness from the TomTom and solder the plug from the new Kenwood head unit to the harness. Had to search on the internet to get the wiring diagram for the 4r harness...

Yea, I had mine turned off, also had those anoying seat belts and air bags removed. Who needs safety devices anyway, as long as you look good that's all that matters. Be sure to sign your organ doner card! Happy New Year! (now i'll sit back and wait for the flame war)

Is the speaker installation well sealed? I replaced mine with 6.5" and the bass was lost until i sealed the door with dynamat.

08 Urban Runner. All my inst. dim together.

Is it possible to put subs in the liftgate? Any drawbacks? I haven't seen it mentioned and was wondering if it is a bad thing. I'm only looking to increase bass a little not to rattle the windows of the car next to me.

I did not install the swi-jack but wish i had. I thought I wouldn't miss the steering whell controls but i do. I will add that in the future. I believe the steering wheels controls were the small square plug that went into the back of the tomtom. If you intall the swi-jack please post how that...

Thanks for the firmware info. Becareful of the BT firmware update, I think that is what caused my problems. I wish Kenwood would give me the old firmware so I could flash it back to 1.43. Are you replacing the speakers? I replaced mine with infinity comps in the front and coax in the rear. I was...

I put the ant. behind the HU under the dash. It came with a piece of metal with an adhesive back. I stuck that on a piece of plastic to the upper right of the little cubby hole (vent duct?)directly behind the HU. It seems to work fine, gets a clean lock on the sats in a very short time even in...

When you get it installed please post how the bluetooth works for you. I have an IPhone 3g and the phonebook doesn't transfer and I can't dial out from the HU. I have not been able to get a solution from kenwood. It worked with the original bluetooth firmware but when i upgraded to 1.61 the...

I installed a kenwood 7120 and the only solution I found was to cut the harness. Worked out fine.

I wasn't trying to knock Bridgestones as a brand, I have nothing against them, but appeared to be something wrong with this particular set. The tech said they had a problem with a few and it was probably a bad batch (which bridgestone confirmed that had a small problem with a batch) or a problem...

the dealer changed out my bridgestones for the michelins and the vibration problem seems to be solved.