Recent content by Shadance

I technically didn't have one.. But r good friend owns the junk yard where we bought mine from n he basically gave me a junked parts one. I thought I was done snagging parts n he had put it out in the back... So I got lucky it was still there... lol

Twan check ur c 27 connector on the back of the instruments. It's the left one in the center pair when u r looking at the front of ur instruments.. My issue was I had power at the #5 green wire but not to the #1 red/green wire.. N if it doesn't go thru there no lights. N I did check my fog...

I got it fixed.... it was my instrument panel.. power went in but didn't come out.. In the one I've been stealing parts out of was a good one so I got it n hooked it up n there were my headlights.. The odometer is off by 40000+ so I will just write on it that it's off due to an exchange...

So the ground is good... tested with my meter. . I spoke with a mechanic friend n he asked if it could hold a load also n he told me how to use a headlight n see if it ran that n it does.... FYI we did pull the dash to check all the diode n such under there n all r good. Power both sides...

K I will check that when I get back home from my toddlers Dr appt.

Not totally sure how to check 16. If taking the test light n grounding it n pushing it into the connection I get nothing.. if that's not what u mean let me know how to test it..

See my post above ur last post.. Kind of frustrated with the whole thing right now since alot of what I've checked wasn't working cuz it wasn't running..

So just rechecked the 4 relay n it has power. Key thing to do when checking make sure vehicle is running....... it doesn't have power otherwise... N reverified that there is no power with just the key in the on position.. so not sure where to go from here if these r all working...

It's good on both sides... I pulled the connector apart n checked it n then put it back in n checked it n test light verifies power. That was a major pain in the but to get out to check..

Got the boyfriend with his meter n he was able to check both sides n there is power to both sides with the fuse in place..

This is with the fuse pulled. Fuse has been rechecked. Not sure how u would check it with the fuse in place...

So the right is giving me 14v n nothing on the other side..

I checked the relay 4 without the switch grounding n have no power showing there. I have used a test light on that at this point. I will check the fuse contact points with my meter.. I verified continuity for the fuse s I know it's good..

So if this quoted right the link from Twan is exactly the same issue I'm having. I have no power at DRL relay #4 terminal 4. I have rechecked my switch after replacing it didn't work thru my Haynes manuel n it is fine.. I get headlights when I ground the 8 terminal (red/blue wire on my...

Haven't done a whole lot cuz I've been super busy but I had a question? Will the #4 relay show power via test light on the 4 wire when the head is on. I know it will click when switching to flash but I couldn't get power with a test light.. I trying to figure out if I have a bad wire nor...