Recent content by shoong

I went with 6 monkeys. I only put my tire carrier on when I go out camping. other than that, I run 33's and it sits in the stock spare storage location. i got the option to mount a table so when i'm out camping it's used for that, my trash shoot holder and clearance.

assuming not kdss compatible?

2021 ORP 2.5" front 2.0" rear 20k miles, no lean, no issues. have taken it thru a lot of road for camping. I don't rock crawl tho.

2021 ORP w/ KDSS. took me 3 hours by myself with a floor jack and 2 x jack stands. This was done without power tools. It is A LOT of wrenching. power tools would drop this time by 1/2.

Not today, but last Friday. Installed my lift and got an alignment. Kings 2.5 front(2.5”) and rear(2”) Dobinson rear springs KDSS rear spacers Toyotec bump stop spacers Wheels are 17x8.5 wrapped in 265/70/17 Wildpeaks Sent from my iPhone using Tapatalk

I have the same set up and I have a slight rub on driver side against my mud flap at full lock. RRW RH7, 17x8.5 0 offset, Falken Wildpeaks 265/70/17 Sent from my iPhone using Tapatalk

Does the toe seem high? The truck drives perfect but worried tire wear won’t be ideal. Suspension Set-Up: Kings 2.5 coilovers and rear shocks 2.5” lift in front 2” dobinsons in the rear SPC UCA 265/70/17 Falken Wildpeaks wrapped around 17x8.5 0 offset Sent from my iPhone using Tapatalk

I second dr.KDSS, Dom is super passionate about what he does and is a super cool dude Sent from my iPhone using Tapatalk

every 7500

Wiring up Baja Designs S8 20" Light Bar + CaliRaisedLED Dual Function Small Switch Hi Everyone, I'm going to be wiring up the two items listed in the title and want to know if where to tap the yellow wire from the switch: this illuminates the switch when I turn my lights on according to their...

Brand New in Box. All components still sealed. $150 shipped to anywhere in the US. Local pick will be near Lawndale in SoCal Sent from my iPhone using Tapatalk

thank you everyone. helped me figure it out. appreciate the help

I'm looking to replace the cigarette lighter in my 4runner with a voltage meter that has charging capabilities: Voltage Meter. I'm looking to reuse existing wires from the 12v. Has anyone done this? I know some of you will reference the plug-in, but this is preference for me.

Finally made some time to paint valances this weekend and install heritage grille. Sent from my iPhone using Tapatalk

I wish you were in southern california