Recent content by sickleficker

yup Yes, you can replace the rear ones with no resistors because they are already wired for LEDs.

Added a flux capacitor with a mini switch.

Flux Capacitor installed I did something similar but mine ended up looking like a flux capacitor. Parts Used: LED Strip: Robot Check DC Connector: Robot Check Mini Switch: Robot Check Mini Switch mounted:

*FIX* for turn signal hyperflashing on 4runner's with dual-filament (7444na) bulbs I have a 2014 T4R Limited with dual filament (7444na) front turn signal bulbs. I switched all the lights over to LED and was having issues with the front turn signals hyper-flashing. After reading all the posts i...

I have the 3 wire setup on my 2014 t4r and i've spliced the load resistor into the White/black line wire (ground), and the Yellow wire (Signal Power). It stops my hyperflashing in the daytime when all that's running are my DRL's (half power high beams) but at night when all my lights are on...

Hello, I was reading your post to the wiring issue of hyperflashing and just wanted to double check what you were saying. I have the 3 wire setup on my 2014 t4r and i've spliced the load resistor into the White/black line wire (ground), and the Yellow wire (Signal Power). It stops my...

WTT 2014 Hood for Trail Hood Hey Guys, new to the forums here; thanks for having me. Wanted to throw this out there if anybody is interested. I have a 2014 limited hood in attitude black pearl (218) that I'd be willing to trade for a compatible trail hood in the same color with the scoop. Pm...