Recent content by silver4est

wow, seems like some pretty good deals of been found by many of you guys. Makes me curious what I should be thinking, Im looking into a 2009 trail edition with 215k on it, its in michigan its whole life. surface rust on frame but does not look to bad from what I saw, seam welds have surface rust...

Sold

will this change the amount it takes to turn to lock one way or the other?

I replaced my steering wheel/shaft assembly with a lower mileage unit I found at junk yard. My original wheel was pretty much exactly straight. The new wheel is 15°+ off center. Can I remove just the wheel and try to center it or do I have to take the whole thing apart again? I removed the 2...

I went for the gold, saw an empty fuse opening next to the ACC fuse under the dash. I picked up a ATM add-a-fuse and 10amp fuse from Autozone, it works! with key turned to at least accessory. I was gonna use the ACC slot and add circuit but this open slot worked. I think I may have been...

installed Piaa 510 55w lights in my bumper, I am doing the wiring now but have a couple questions. I am using the piaa wiring harness which is simple enough, I have the relay and fuse close to the positive battery terminal, using the same ground the battery grounds to. I am debating what to do...

lets see this bumper

bumper flares sold driver fender flair still available

70 shipped for the pair, they are ready to install if your looking for millennium silver, rubber seals are intact as well;)

bump for cool stuff

bump for useful stuff

bump for cool stuff

Yes you can attain the same result by replacing the slip joint, but this way saves lots of dollars. My question is, can a pre 98 steering shaft be used on a 99+? those did not have the slip joint correct? I have not been able to find anyone local that will allow me to do this, not even farmer...

selling Greddy infometer touch, plugs into OBDii port, I don't have much use for it, takes up my glovebox space. Works with all OBDii japanese cars I believe. Also will display trans temp, but I do not have the wiring for that. 200 plus shipping, located in Traver City, MI. GReddy

Removed this Next Venture Motorsports front reciever from my 2002 when I installed 4xinnovations front bumper, was originally installed in Arizona, seen one Michigan winter and has been Krown coated inside and out. Very minimal surface rust on bottom. Have longer mounting hardware as well...