Recent content by Six_Actual

OP, Im super curious if you have this figured out. Here’s what I’m working with… 1 - this lever folds down the headrest 2 - this button lowers the headrest 3 - this button folds down the seat. Each button only controls one action/direction. Let me know if this helps.

There are a few steps… (For the drivers side rear seat) Shorten the headrest to a low height by pressing the button on the outside/left side of the left headrest base and pushing down on top. You way need to wiggle the headrest to get it to drop. Fold the headrest forward by actuating the...

Came out to Big Bend, saw a slitherer...

I went with Icon 2.5 VS IR Coilovers. The Bilstein 6112's were great performance-wise, but I wanted 1" more lift without having to add 1/2" spacers and mess with the finite settings of the 7 position circlips. My rears are still the Bilstein 5160's with 2" lift springs... for now ;-)

OP, your planned setup will work well for level (or slight rake). I ran that setup with Bilstein standard weight springs. I don't know that they are soft (as someone else state). They are more firm that stock and feel good IMO. Did you decide on anything yet?

SOLD! FS: Bilstein B8 6112 lightly used suspension kit that just came off of my 4Runner. ~6K miles on them (5,850 on road) Lift is 0 - 2.75” This is the standard weight spring kit. Kit Part #47-259768 Individual strut #24-259118 Great performing shocks, but I have since been upgraded for...

I am selling a lightly used suspension kit that just came off of my 4Runner. ~6K miles on them (5,850 on road) Lift is 0 - 2.75” This is the standard weight spring kit. Kit Part #47-259768 Individual strut #24-259118 Great performing shocks, but I have since been upgraded for even more...

Im tired of searching for a shop to do my cut so Im doing it myself. Still need to find someone to weld it though...

Hear me out... my bad on the delay... I've just been gone. Wish i had a diagram but... The head unit is HD velcro mounted on the inside of the back wall of the center console/arm rest box. This port extender cable travels up the right side from the center console around the 4WD shifter, behind...

Thanks. Uniden CMX 760. Great form factor as a tiny unit. All controls are on the handset.

Finished my CB install... I wanted a super clean almost OEM look.

For closure if you need it haha... I pulled the trigger and I love how it turned out. Pilot hole confirmed I could drill from the back. Found some cool black clip mounts for the mic too but I didn’t get a picture. Thanks for the help folks.

Thanks for the replies. (It took me a while to get back to this post because I couldn't find it on my phone). Looks like I should drill from the front... and good tip on the masking tape. Will do. I'm going to mount an RJ-45 port insert to connect my CB radio (and maybe another one somewhere...

Wheelers also makes/sells an aluminum version.

I’d like to get in on this. Sending PM for pricing. Count me in if its not too late.