Recent content by SparkySparks83

Mine should be showing up in the next few days! Hopefully, my power steering cooler shows up as well since I don't really want to pull my front end apart multiple times.

It's a cover to protect the passenger fog light due to the air intake slots in the fender liner.

I replaced my stock horn with a 4 note from an old Cadillac, sounds little like a train and is nice and loud!

Almost $400 just for the panels, guess I'll stick to folding panels.

Had this happen right before the big freeze down here in Texas a couple of weeks ago. Luckily I was only getting a code for number 4 cylinder misfire and doing a quick look I could see some droppings, acorns and a missing section of wire going to the number 4 fuel injector. I ran and picked up...

The OBDLink will show tire pressure and temp but it is a generic sensor 1,2,3 and 4. You also have to select the correct module to read the TPMS.

8 don't have any of those stickers in the same location on my 2018 but I did notice similar stickers over holes in the bottom side of the body when I removed my OEM steps and installed my sliders. Looks like it is just there to keep stuff out of the holes.

Will the factory panel be secured differently (something other then the plastic clips) or will this MOLLE panel actually mount to the metal behind the factory plastic panel?

I wonder if the weight limit is on the ladder side or the hatch side. I could see some of the ladders on the market holding 300+ pounds but with the way it is attached, not sure i would trust the hatch to hold up to 300+ pounds.

Mine fit nice and snug with no gaps. I've had the windows all the way down and up to about 15mph and 35mph with the windows half way down without them moving. My son loves them!

I went with a set of snap shades as they allow the window to still go up and down without removing them. I would trade the ability to open/close windows with them in place for an option to fill all doors, hatc and sunroof with screens! Toyota 4Runner Car Window Shades (2009-Present) | SNAP SHADES

I saw a few really clean installs with it mounted on the headliner in front of the overhead console. I have a sunroof so that wasn't an option for me so I when with the SDHQ mount. If I had it to do over again I would just use my stock one. The only downside to this location is with dark tainted...

Just did my first oil change (first one I've done, the rest were part of the free ones from Toyota) and I decided to switch to the metal housing. I tried the plastic drain in the metal housing before installing it just to see how it worked compared to the plastic housing and I had to nearly...

Not replaced the windshield on the 4runner yet but on two other vehicles multiple times I've used Safelight 5 times to replace my windshields. I've always done it at their shop as they have a controlled environment, plenty of room and a flat survive to work on. I've always left with my car...

Not completely true about the ECU Tune being "snake oil", it is similar to swapping out the jets on a carburetor to adjust the air fuel ratio and turning the distribute to adjust timing. You can lean out the air fuel mixture and add timing (as long as you can avoid knock) and get some more out...