Recent content by Specjay

Yes I saw that instantly but TRD wheels have pocket that allow the stud to protrude from spacer. However, Not the stock Trail wheels so I had to grind a really small bit of the rear studs. I'm starting to think that I will remove spacers, rubbing and vibration on my new truck, I don't like...

I am very meticulous to clean every surface in contact each time I remove wheels, I'll start from beginning by the end of the week. I'll remove spacers and put my new wheels, if it still vibrate, they will have to balance it better. Another question: I did move fender liner 1 " forward and...

It was done at my local Toyota dealer and they said the machine cost them 20000$ and it is brand new.

I installed the Bora 1" spacers yesterday and I also switch to summer tires (new BF KO2 mounted on TRD PRO wheels), At 90 KM/H, it start shaking and at 110KM/H, the steering woble a lot. I tried to switch tires from rear to front and it was worst. The guy told me these tires was hard to...

I looked on Toyota Canada website and by entering my VIN, they doesn't advise of any recall ... I tought the canadian T4R was the same as american.

Thank you guys, I do have the heated switch but not the Party mode so it's gonna go there.

I ordered one just now . Where is the best place to put the switch and which one are you recommending ? I have a Trail Edition 2016

Wow thanks again, It is very visual with comparison on that link !! Add this to my favorite. BTW, I'm in contact with Lenny, he provide a good service !

With my Trail OEM wheels, I'm sure the stance with be perfect with 1" spacers but this summer with my TRD PRO wheels, I am not sure. Here is the specs of both wheels. Stock Wheel 17 inch x 7.5 inch x 15mm offset TRD Pro Wheel 17 inch x 7.0 inch x 4 mm offset Pro wheels are half inch less wide...

Thanks for you answer Scharfschütze, I was hesitating between 1inch and 0,75. I will probably order the 1inch soon, price is not an issue, I want a better quality so I will order Bora's. Can you post pics when it will be on ? My truck is stock so even with OEM wheels and tire size, I will have...

Hi, Like I asked in an another thread, I have bought TRP PRO wheels for summer and will keep my stock wheels for winter. My question is can I put a little less thicker than 1.25" , like .075" or 1" to have a better looking stance ? oljedi11950 member told me to go with Motorsporttech/bora out...

I wish to keep my 2016 TEP at stock height for now, but I would like to add spacers, I look at the 1.25" spidertrax and it seem to me that it's a bit too much, rocks and dirt would hit the doors and rear bumper. I have bought TRP PRO wheels for summer and will keep my stock wheels for winter...

Bump ^^

I just bought a pair of black strong and flexible and I would like to keep the matte finish, can I just use primer and the flat black paint and still have the UV protection ?