Recent content by Stevec717

It's a 2008 Sport. It has the OE 6 disc system (non-JBL).

I'm about to start upgrading my audio. Can you all give me some tips for getting the door panels off? Are there any screws around the door handle, etc? Are the clips/buttons truly re-usable or should I have some spares on hand? Thanks ps- Circuit City has Polk Speakers at BOGO 1/2 off. I got...

OEM XM Well, I realize it may not look as cool, or have as much display capacity, but I just finished an install of the Toy factory XM kit. It's not cheap (about $250 for the tuner and fit kit.). ANd it took me all day to do the install (total disassembly of one side of interior). But all...

Anyone? I think I can go to jail for that. But if someone needs a particular thing - I could look that up and we could "discuss" what they're looking for. I actually just got the XM Kit (Factory) and it came with NOTHING for instructions. While I could probably figure out a decent...

I had to buy TIS access for a day. Anyone need a bulletin , instructions, etc. let me know TODAY and I'll see what I can find. Steve

IDEAS 4RNR FOURRNR FORUNNER FORERNR 4RUNNER OH4RNR 4RUNINOH I don't know -lots of options.

New Pics! Took our first trip this weekend with the new 4R and took a few pics. Here's one for the thread.............(I know everyone likes pics)

And Both........ Here's both done. I was overall very happy with the quality and delivery of kit, ease of install and the outcome was amazing. If you're thinking about this - just do it!

Finished! I was able to pick up a factory ground right on each side and was able to cross over power wire from pass side by routing under radiator support right along factory loom. All wiring is secure and out of sight under pastic shield once replaced. 2008 seems to have low beam "projector...

More......... More mounting

Other mounting I mounted the other 2 components (I know one is a ballast, not sure about other one) . One fit nicely on the side wall, the other on inner fender. I did use the double sided tape to prevent rattling, but used 1 self tapping screw for security.

Relay Mounting There waqs an existing hole in front panel which allowed for a through bolt (stainless of course). I did similar on drivers side.

Pass side Headlamp Here is pass side headlamp before work.

Wiring Prep Then, pop up connnectors to remove plastic shield over radiator. This allows clean wire installation to pass side.

Well you all convinced me to try a set of these HID lights. So I ordered a 4300 kit from Xenon Depot. Ordered Monday - received Thursday - SUPER fast!! No instruction at all, but not complicated. I took pics in case anyone is thinking about doing this but isn't sure. All in about 1 1/2 hrs...