Recent content by Stretch1100

I cleaned my IAC and put a new gasket on it and the throttle body and it's not as bad as it used to be. I also had a new muffler put on at the same time as mine had a hole in it. Sometimes I can still feel a resonating vibration from the gas peddle while driving.

Yes cleaned MAF and have stock NGK plugs and I just checked them again an they're all tight

My plugs and wires are like new only a few months old. It never misses or anything and has full power.

I cleaned my IAC valve yesterday even though my idle is fine. It wasn't that dirty but that stupid o-ring type gasket wouldn't fit back in the recessed area so I just used sealant and it works fine. Vibration still there. It seems like it takes a few seconds of sitting at a stop light before you...

No CEL. I notice it more when it's cold but it's still there when it warms up. What should the idle be at while in gear with the brake on? I haven't cleaned my IAC but I did do my throttle body. I also saw on another post that it could be a lose or bad tranny mount.

The vibration comes and goes while sitting at a stop light while in gear. Runs and idles great. Feels like a motor mount maybe but wouldn't I feel this when driving as well? What does dealer charge for replacing a motor mount if it's bad?

I know on the older BMW's they're actually designed to do this as it helps bring the tranny up to operating temperature. Don't know if our tranny computer is that sophisticated.

When I bought this truck a few months back I had the tranny fluid exchange done on it. The guy said the fluid wasn't bad at all that was in it but I wanted it done. I then drained a bit and put the Lucas tranny additive in it since I tow my boat a lot. As I've never driven this when cold before...

I personally would stick with something around 4300k which is the stock temp of the BMW zenons. Anything higher then that and your going to be blueish or purpleish.

Since I already have the hid bulbs and ballasts all I need are the projector lenses themselves to retrofit my stock headlights. I'm not able to find just the HB2/9003 projector lenses. Anyone seen these? All I'm finding are kits with the projectors and bulbs/ballasts.

I was replacing some dash and switch bulbs the other day and I noticed there's a bulb (A3 I believe) in the rear diff lock switch but it doesn't illuminate at any time. I even replaced the bulb with a known good bulb and still no illumination when I had the parking or headlights turned on. I...

I have a 97 Limited, it's my first T4R. I've noticed a sound when I first start her up it sounds like the ABS or anit-lock braking system is cycling or pumping for a brief second. Is this normal? Again, I only hear this on start up. I mysteriously had a blown brake light fuse awhile back and it...

I'm one of the "drop HID's into my stock headlights" guys and I'm getting flashed offend. I have the 4300k bi-zenon kit. I'm going to try and aim my lights down to see how it affects my vision and frequency of getting flashed. For those that have converted to projector headlights how hard is it...

What condition are they in? I'm just needing the front and rear toyota symbols. Really just the front but if the price and condition is right I might be interested in the rear as well. Can you post pics?

TOYOTA 4 RUNNER TAIL LIGHTS, CORNER LIGHTS, FRONT TURN SIGNALS AND THIRD BRAKE LIGHT FROM 97 4RUNNER SHOULD FIT 96-00. COMPLETE SET IN GREAT CONDITION WITH LED SMD LIGHT BULBS! OVER $80 IN LED BULBS ALONE! (third brake light and front turn signals are new incandescent bulbs the rest are LEDs)...