Recent content by Tamaki

I was going to use this switch. Amazon.com: CH4X4 Push Switch for Toyota - VSC Symbol - Amber Led : Automotive It's a toggle switch not momentary like OEM. A word of warning. The switch will need to be disassembled and resistor R3 removed. It causes an error if used for the standard VSC off mod...

Update-No Workey Unfortunately no luck. The skid control ECU goes into error mode if the signal from the diff lock is grounded without also grounding the 4wd computer as well. After looking at a the diagrams I noticed that the green/red stripe wire for the diff lock light from the 4wd ecu...

NOTE ALL DIAGRAMS IN THIS GUIDE ARE FOR ONLY 2007 TOYOTA 4RUNNERS. THIS MAY WORK FOR OTHER MODELS (FJ, TACOMA) OR OTHER YEARS IN THE SAME GENERATION HOWEVER WIRE COLORS AND CONNECTION POINTS MAY DIFFER. I had the unfortunate pleasure of experiencing the dreaded loss of power when the VSC kicked...

Prevents damage to the valve stem from loose rocks. OEM valve stems can be easily damaged. OEM TPMS sensors are one piece and stem replacement is impossible without replacing the entire sensor. This cap directs the force from an impact into the stronger lower valve stem and surrounding wheel...

07 v6 SR5 gut check on this suspension upgrade. I intend to add heavier (OME?) springs to the front when a bumper/winch/battery is added in the future for now the 2.5" lift will come from the 5100s setting. A cargo trailer may occasionally be towed otherwise 100lbs constant load in the back...

how's the rust down there with the salt?

Where'd you get the rear toyota sticker?

We tried to use the highlander as a 4runner for too long. Glad we both found one.

Looks like you figured it out.

This post requirement seems like those participation posts in online class. Everyone says something nice and nothing useful gets done.

Great color.

Looks good! I know it's not for offroading but that mirror may be useful for wheel placement.

You are. I'm not... yet

Sounds like you shorted something. Check the fuse for the interior lights. In the future it's a good idea to separate any modified wiring from the stock wiring as much as possible. I'll usually setup distribution points for any stock electrical functions that I need. That way I'm only tapping...

This would be a good sticky in the new members area.