Recent content by tb-av

Thanks, I'll check that vid. What I meant by the PVC or wood is so I can get the window up and actually drive, work, go to store, etc., uttil I can diagnose and get parts.

ArthurKotb thanks for the link and info. I was just watching someone rebuilt a window motor and he mentioned that humidity can cause them to fail. It was really humid yesterday and I have had my sunroof or something leaking down in that area of the vehicle. My main concern right now if getting...

Thanks NYRunner ... I added a few more details to my post. It's the drivers front. My window as I'm driving. I can't believe I'm unable to find a YT video for this problem on the 5th Gen.

Was driving today and rolled down my window. That was it. Did not hear any noises, nothing unusual. It will not roll up now. All other windows operate normally from my driver side controls. The lockout switch works. I don't hear anything like a straining motor and have not heard anything of...

Thanks! Yes, I think you are correct. I looked it up at a site named ToyotaPartsDeal and I can see the cuts for the sensor in one of the photos. Plus it's twice the price of the rear handles. Thank you. Tom B.

I just want to be sure I have the correct part number as I'm seeing a few different ones. 2011 4Runner Limited Rear Drivers Side exterior door handle. It is broken at the most forward point if that matters as far as maybe ordering any extra pieces. Also that cap that is towards the rear dos...

EDIT: I think I got it figured out. Only need the weatherseal / belt

Just a little additional info might help someone. For the front, you will need large twweezers or long bent needle nose pliers to grab the drain tube so you can lift it up... and replace it for that matter. For the rear I was unable to run trimmer string through. The larger size I had with...

Thanks, will do!

Thanks, that sounds like good advice.

Any issues removing? I have 150K but not sure how old they are. Bought with 100K so I know there are at least 50K. Just wondered what to expect.

I always thought that was a roll sensor. If you look in the repair manual at least for 2010 they show another one exterior center towards bumper and one driver side rear door area / maybe cargo area, can't tell.. Seems like nothing over on passenger side regions. I agree with you though if...

Thanks , my repair parts arrived today... 4 days early !!! I read all of that info and se the connectors / wires but in the "C" section I can't figure which connector they are demonstrating. I have tried several areas and can't quite figure which piece and where I am supposed to trying to pry...

I've tried that and it still won't release. One problem I have is that the wires are chewed of right flush with back end of connector so I can just barely pinch about 1/16" to 1/8" of wire but can't pry -and- push / pull it. It just slips away. When you say "top" I don't really see anything to...

OK, yes. Def. 11162 and I suppose the internals are on page 347 center page next to block letter "F". 6mm low insertion force. Still can't quite figure how it comes apart. I'll read through the instructions later. Thanks for the info. TB