Recent content by TeamShiftPoint

I've bought some parts from them before for my GS and had no issues. I've seen a couple posts on FB about the TPMS that some 5th gen owners have ordered. All the other post that I have seen were for other Lexus vehicles and they seem to have no issues either. supposedly there are some on...

Check this one out. https://www.instagram.com/p/CfsqZlLqEbK/?igshid=OGQ2MjdiOTE=

Thanks for the input. I was looking at the ones from Dobinson also since I was going to get the MRR setup with LT in the back. Dobinson are also bushings on both ends and they don't look any beefier than OEM and cost more. I am also looking at possibility of loss in rear travel/droop going with...

Anyone have any feedback or experience with these trailing arms? 2003-2020 Toyota 4 Runner Adjustable Trailing Arms – Apoc Industries

Mike, I have your front disconnecting swaybar links for the 5th gen 4runner. How can i get 2 replacement spacers that the little pin goes through. Both of mine are all mushroomed on the bottom side cause they sometimes hit the outer part of the heim joint when steering is fully turned to one...

My QD front pins that hold the collar on place keep rotating and the ends bend when they contact the sway bar end. Makes it hard to get the pins off. Had to replace them 3x already. I carry spares I got off Amazon.

Mike, Can you let me know what size quick release pin is used for the front disco for the 5th gen? Mine are bent or stuck or have the ring pulled out. I need to replace one of mine. The bolt sometimes rotates and allows the pin to interfere with the stock sway. Thanks, Will

I saw this one too. Trying to find something that uses oem sensors and not the sensor caps that can get ripped off in the mud/offroad.

I have a scan gauge ii but on my other vehicle might send it in for update. Looking for something more standalone/single purpose.

I'm interested in something like this too. I found this but it only list Fords and Lincolns. TPMS Live | Know your tire pressure live | Bartec USA

just picked some up earlier this week. stout stuff. They had them on the shelf, ready to ship, raw metal.

Shrockworks has them on the shelf, raw. I believe powder coating is +2wks.

MStudt going to PM you about some links for a 5th Gen.

Has anyone ordered the pre-filter sock for the TJM snorkel or know if any other alternative besides using an oiled sock that you wear? Dust and dirt goes into the snorkel very easily if you are traveling dirt roads esp. when traveling in a convoy. I didn't have a pre-filter this past weekend...

When's next round?