Recent content by thatoneguygeoff

Where did your 4runner take you today? Mine took me up to the back side of Big Bear in search of some coyotes. I didn’t get any shots off on any unfortunately, but one did bark back at me at one point. That sure gets your heart racing! Sent from my iPhone using Tapatalk

And today in the garage, EIM Keith lower control arm gussets. These were a super easy fit up with minor fitting. I’m glad I did these because I found out that my passenger side shock mount was cracked in 3 places! While the arms were off, I also installed the Whiteline bushings since mine were...

So I was doing some testing with my solar panel last weekend with the radio up pretty good. The weather was really nice and sunny and my solar panel was working fantastic! It was making just about as much power as the radio was taking, and actually running to its full potential! Sent from my...

I always forget to update my page. By the time I remember, I’ve done 10 upgrades! Haha. Next up is Whiteline LCA bushings and the EIM Keith lower control arm gussets. Might tackle that this weekend. Sent from my iPhone using Tapatalk

I built this one entirely from scratch. My factory rack is laying against my garage. Sent from my iPhone using Tapatalk

It measures 23" on the dot.

Thank you! The rack is mounted with the factory 10 screws and the front is supported by 2 5/16" swivel feet and rtv'd to the cab to prevent any fluttering.

I cant recall the exact measurement but my numbers may differ from what yours will be based off of the way your rig is setup versus how mine is. I may have more or less weight on my rig than you do on yours.

I bought my Kings and Camburg uppers from CJC Offroad.

I left that inner 3" un-welded for now since my tank was full and too heavy and awkward to drop. Ill weld it up in a week or so when my tank gets below 1/4.

Finally pulled the trigger on a set of OME 861's. Now my rear sag is gone when loaded down and the ride has improved a lot as well!

Yesterday I got my EIM Keith lower link reinforcements welded on. I had planned on tig welding them on, but the gaps were a little too large for me to do it cleanly. Ah well, they came out just fine with my mig. They got topped off with 2 coats of Steel-it as well.

Well I finally got around to building my roof rack a couple months ago. It is made out of 1" .083 wall mild steel, and completely tig welded. I also installed the Renogy premium 100 watt Eclipse solar panel kit.

Here you go.

All of my lights on my 97 4runner are Surf and I do have the side markers installed. I can get you pictures tomorrow and measurements. But as for the hole size I have no clue. That would require me to remove my inner fender well and thats a pain sorry.