Recent content by TheJokingExplorer

  1. T

    How bad is the dealer gonna F me...?

    I have no vibration when braking.
  2. T

    How bad is the dealer gonna F me...?

    I agree which is why I'm having a hard time believing that this axle shaft is so out of spec that I need to spend 2k replacing it. Especially since the only symptom is a small squeak hear and there. At the same time I don't want to "assume" I know more than what I really do and then down the...
  3. T

    How bad is the dealer gonna F me...?

    According to the 4runner service manual from Toyota. The maximum rear axle shaft runout is 1.50mm and the rear axle flange runout is 0.05mm.
  4. T

    How bad is the dealer gonna F me...?

    No abnormal wear pattern on my rear tire.
  5. T

    How bad is the dealer gonna F me...?

    Good question and I don’t know. It seems the new brake pads got rid of the squeeking when I brake. However, I do have some squeeking when the rear drivers side suspension is compressed but no vibration.
  6. T

    How bad is the dealer gonna F me...?

    I think they are talking about the axle flange?(correction, it must be the axel shaft) Here is a link to the video Toyota sent me showing the rotor out of alignment. https://imgur.com/a/6fGPBdi
  7. T

    How bad is the dealer gonna F me...?

    Ive had my 2017 4runner for about seven years never with any problems. A few weeks ago my drivers side rear brake started squeaking only when I would brake. No problem this has happened before just replaced pads and it was back to normal. Normally, I would jut replace the pads myself but I just...
  8. T

    2017 Transfer case capacity?

    Just changed my transfer case fluid on my 2017 SR5P. I changed it last around 30k and I could have sworn it took around 1.2-1.4 quarts. I doubled checked how much Toyota calls for and what do you know roughly 1.4 quarts. Today I was only able to get 1L in before it started running out. Vehicle...
  9. T

    Cross bars alone

    Anybody know of just stand alone cross bars? That just mount directly to the factory bolt points without the factory side rails. I saw one set but don't know the brand. TIA!
  10. T

    Selling Frontrunner Slimeline II 3/4

    Sure, I Still have both.
  11. T

    Selling Frontrunner Slimeline II 3/4

    Bump Still available.
  12. T

    Had to go back to using the plastic oil filter housing

    I swapped my plastic housing for metal one about 65k miles ago 2.5 years and no leaks. Will check tomorrow though.
  13. T

    GFC Superlite RTT on a Sherpa Crestone

    Did you use the hardware that GC provided?
  14. T

    GFC Superlite RTT on a Sherpa Crestone

    Not sure how the prinsu compares to your racks cross bars. I mounted my superlite with 5/16-18 x 1-1/2 from Home Depot. they fit perfectly. 4:08 talks about how I mounted it. GFC Superlite Initial thoughts (5th gen 4runner) - YouTube

Members online

Forum statistics

Threads
278,307
Messages
3,554,054
Members
248,016
Latest member
Advally Service
Back
Top