Recent content by TJQ

Price drop! $1200

Bumpity

No interest? Pretty much buying tires with free wheels.

Not at this time.

17x8 0mm offset. 4.5 back space 6x139 procomp series 1089 wheels. 285/70/17 Goodyear Duratracs. 485 miles on wheels and tires. Houston Texas pick up only.

slight pull to the left but other than that drives great.

Thanks for the info. I figured I would need the aftermarket UCA. But at the moment I dont have the spare $500. So I need to do some trimming for the time being and just wanted to see how it was done from those that have done it.

No spacers. Its a full lift.

They are great engines but I wouldn't say they run forever. If I was faced with 1k replacement I would definitely pay an additional $1500 to have a zero mileage engine again. But Im a DIYer. So when the weather cools down. I'll change it myself.

Toytec 3/2 Caster after lift but before tires was 0.8 left 1.0 right stock UCAS. I need to get it checked again.

Absolutely not. Sell it to me :thumb3:

We have engine builders in the area that provide rebuild toyo v8 for $2500. Obviously you have the added expense of install. But going this route gets you 0 miles on the clock as well as resolving your oil leak. I have 127k and need to get timing belt replaced. But with estimates of...

So I went 285/70/17 Duratracs. Anyone have any pics handy of how they trimmed the rear of the front fender after the mud flaps were removed? I did the front liner push and trim but the back of the front fender rubs "flexin" when I pull into my parking garage :) The rubbing has given me 3 new...

Successful cv axle replacement today. I avoided it for 2 months because I didn't know whether I needed a 35 or 36mm socket. I bought a 36 but needed a 35. So I used the 36. Pretty simple task. Luckily the diff plugs came out easy because I forgot to remove them before I pulled the axle.

Replaced pass cv axle, changed diff fluids, cleaned mass air flow and throttle body, and topped it off with a good old fashioned driveshaft lube job.