Recent content by TMP

Just ordered the 698 kit! Can’t wait to install it.

289,xxx - going strong!

Great thread and I also want to give a huge thank you to Tim and Sean for all their hard work in bringing these videos to life. They have saved me so much guess work and pain!!!!! Just did my valve cover gaskets after watching the video about 5 times! Next up is LCA bushings and tie rods...

Valve cover gaskets, plugs, wires, pcv valve and grommet, clean throttle body... and lots of parts cleaning. My first time doing this and took most of the day. I have a check engine light now which should turn off in a few days.

I installed a set in May. No issues so far. I'm Denver so was easy enough to drive over and pick the up.

Yeah, it shut no prob with one seat down.

More New Mexico

New Mexico - AUGUST 2019 Meow Wolf:

Leaking seal on the hub so replaced it and also went with long boot CVJ CV axles. Was a bit tough to get the seal out. Here it is all cleaned up : CV's Pop this out with a crow bar: Installed

HAM YAESU FTM-400XDR Made a tiny little hole in the firewall grommet and fished this thru: Ladder mount : Antennae folds and swivels so I can open the hatch with the kamper on and back into the garage.

JULY 2019 SR8 / Duratrac 285 upgrade! Pinch weld mod:

TBU - pedal isn't 100% where I want it. Bled several times, did the haul ass and stop the brakes to engage the anti skid... still not quite there. Stops no problem but the pedal still bothers me a little.. It feels different. Extended rear lines (Toytec)

MAY 2019 LED's in the rear for reverse... huge difference! Stock LED

I jumped on the iKamper via Kickstarter... it took forever to get it but I'm glad I did it. It wouldn't fit in my old garage so sat on its side all winter. Then it lived on the runner for a few months until I moved and bought a new house in March that had a bug garage. The pulley system is...

MARCH 2018 iKamper fits in the new garage! The ceiling mounted pulley system (THULE)