Recent content by Todbld

I just installed the Borla S-Type Cat-Back Exhaust Systems (p/n 140760) on my 2013 Trail edition 4Runner with kdss. It fit great no rattling on heat shields. No drone on the highway and it’s slightly louder than the stock one at idle. The S-Type model has no exhaust tip, just a angled cut pipe...

I picked them up from FN Wheels. Dustin is on point with customer service. https://www.fnwheels.com/new-products/konig-six-shooter/ 17x9 0 offset 5" back spacing

Here is a pic of the exhaust tip. Come with all the mounting hardware.

I'm up in the air at the moment... Ordered Bilstein 5100 all around, Camburg 1 inch rear spring and Camburg UCA. First thought, 2.5 in the front using the adjustable collar on the Bilsteins and pop in the Camburg spring to raise the rear 1 inch. Or shelve the rear spring and just raise the...

$25 and I'll ship it to you. PM if interested. I have the exhaust tip as well.

The front doesn't rub at all. The rubbing is on the front mud flap on the inside. Should go away once it's leveled.

There is slight rubbing on the front mud flap. Should go away once its leveled. Could trim or heat gun it but it's so slight it can wait until I put the lift on.

2014 4Runner Trail Build Up close pic

Just got the rims and tires on the 4Runner. Went with 17 inch Konig Six Shooters with BFG AT 275/70/17. Going to put some Bilstiens on in a week or so to level it out.

Here is a picture installed

I installed a FJ Cruiser shift knob on my 4Runner. I hear that some cut the shifter down to get the fit just right. I just popped off the bottom instead of cutting the middle and it fits great. Look good too.

If your looking for aftermarket wheels, I got a set of sweet 17's from FN Wheels at a great price. FN Wheels

How are the BFG's working out? Your rig is awesome...

Quick question about the lifting over 2 1/2" not to do that 1Engineer left. It would be nice to get his thoughts on that. Seems that most common lifts (ToyTec, OME) are 3 inch. I was considering the Toytec/Bilstein height adjustable coilovers 3 inch and 2 inch Camburg spring with Bilstein 5100...

The cleanest ones that I have seen are make by ShrockWorks.