Recent content by toyota_tx

  1. T

    2003 Shift Cable Problem

    Shift Cable Easy Fix
  2. T

    Fixing the transfer case shift motor leak from within..

    we are discussing the seal failure on the actuator, the resulting leak is a few drips over time. If you have a puddle, it is another issue, like maybe the front driveshaft output seal blew out, or it has been overfilled or otherwise messed with. I'd degrease and pressure wash it all and...
  3. T

    Fixing the transfer case shift motor leak from within..

    Large O-Ring refers to the one on the Black Actuator as it slides into the transfer case housing. The groove it sits in is wide enough for 2 O-Rings, and that is what I put in, 2 O-Rings and an added dose of RTV. And yes, the open hole you circled in the picture is what I plugged by forcing a...
  4. T

    Fixing the transfer case shift motor leak from within..

    They are full of you know what. the tech is inexperienced with the model, and not up on reading the TSB's about the issue. Run away as fast as you can.
  5. T

    Fixing the transfer case shift motor leak from within..

    I must commend MandAtaco for the best write up on the net for this, not involving an actuator tear down. Stay away from all those pull twist and crack articles, the info dosen't even apply to the two shaft actuator. You can buy new actuators from the OEM who is AISN, not TMC, Dorman is even...
  6. T

    DIY: Interior LED swap (cluster, HVAC, switches, window, *steering wheel)

    Cup Holders and Center Console Shifter were both 74's, as are the directonals, and glove box
  7. T

    Post Your LED Gauge Swaps Here

    no need to wire the negative side, just the positive sides. I solder both hot leads to each other and then over to the hot side of the Neo3 led that is used for the RESET/MODE back lighting and now have plenty of voltage avail for all 3. And can now be switched on/off with the headlights, ran...
  8. T

    Replace interior/license plate lights w/ LED's

    The OFF, Temp UP, Temp Down do not have lights(LED's) behind them. From left to right, the LED count is 4, 2, 5 for a total of 11, 3MM soldered lead type LEDS, just changed all mine to white, with blue Neo3 for the background. background are somewhat dimmable but the whites are either brite or a...
  9. T

    Changing factory radio color

    it is possible, just had it apart and it is similar construction less the flip up. There are roughly 30 SMD's but they are tiny, maybe 1/3 the size of what was seen in your Neon pictures. Will lo into it further as Iv'e just finished the HVAC conversion to blue background with white accents.
  10. T

    DIY: Interior LED swap (cluster, HVAC, switches, window, *steering wheel)

    airbag LED in the center console and cautions The Air Bag / Passenger & Security lights in the HVAC cluster are 5MM Red LED's and can be desoldered and swapped without removal of the LCD. I permanently removed the Passenger LED, and changed the Security to Blue. Biggest danger in swapping...
  11. T

    Gold Emblems

    reason for 90's Gold Leasing was strong in the 90's and a slick way to bump the residual value was to load it up with port and dealer installed options. So they could bury the trade in payoffs or over mileage fees easier. Corollas were getting sunroofs spoilers rain guards alloy wheels gold...

Members online

Forum statistics

Threads
278,310
Messages
3,554,080
Members
248,016
Latest member
Advally Service
Back
Top