Recent content by tpotnoc

Did the new shaft correct the issue? A lot of threads I see describe stiff notches in the steering, but mine is stiff from lock to lock pretty much and only when I’m stopped on the pavement. Was yours constant stiffness pretty much or only in certain positions?

Ever figure this out?

Dude, very clean. Thats a cool idea. I have a quick connect plug on the power cables so no need for a switch. If I can find a simple way to relocate the connect, I'd just do that. Your idea is pretty clean as far as getting the plug to sit in that box. As far as location, my air compressor is in...

All of the instructions for the ARB Summit winch install show the controller exposed on the top side protruding from the top. Has anyone figured out how to mount the controller inside the bumper and still manage to access it to plug in your remote? I have the bumper and my Smitty XRC waiting to...

Hey, these photos arent loaded anymore. Do you still have them handy? Hoping to see the difference.

Hey do you still have your truck with 327 coils in the rear? I’m in the process of going with the Dobinson setup by I for the life of me cannot decide between 325 and 327. How is the ride when the car is empty? Super stiff? Uncomfortable over bumps? How does it compare when you get fully loaded...

Good info. I like the rake, but more importantly, how did it drive on your normal daily driving when the cab was empty? I have sliders and a roof rack with occasional RTT. I’m in between the 325 & 327. The last thing I want is a jarring uncomfortable ride when I don’t have any weight.

Hello all, from three years into the future. Getting ready to order my Summit, but very curious if anyone is running an RCI skidplate with this bumper. I want to see if they interfere or if they can be mounted together without issues. ARB nor RCI can confirm.

. Looks pretty naked without a winch, too. lol

Thanks for sharing all this knowledge. Can you share the bleeding/pressurizing procedure that you followed?

If I wanted to keep my factory 2” rake on my Off-road, should I be lifting front and rear the same amount? Or should I lift the rear higher than the front? I’m looking at Dobinson c59-300/c59-505

Is there any active picture threads with various Dobinson setups? Looking for pictures of the 724/723 setup, but the search feature is useless. :(

These bearings are failing that early?? You felt yours at 5000 miles? Holy crap. On a side note, why the hell are they replacing an entire front diff for a needle bearing? That seems a bit invasive.

Very nice OP! What do you use to prevent the awning from “hanging” off the bars? Seems like it wouldn’t be solid using ubolts on a round bar!

Nice! I can get about the same measurement on my Curt! Win