Recent content by TraumaHawk

The tube is welded into the swingout. This is the pin that goes into the welded tube. Not looking to refab a different spring pin, just the replacement part. I found the spring pin assy a few years ago online for a different project but didn't buy it. If I could figure out what vendor...

I found that as well. The length is too short.

Great weekend of wheelin but the rear swing out at one point never made it fully closed and swung wide and pop, the lock out pin broke off the end. Shrockworks is out of business and I have looked for this pin online for a few days with no success. Any leads would be most appreciated at this...

yikes, that is a serious case of Fe2O3.

Anybody running these? Reviews? 1996-2004 Toyota Tacoma 4Runner 6 Lug Lifted Front Upper Control Arms 2 Inch-4 Inch FLASHARKSKU: FLOS08437BK Price: Sale price$219.99

You don't happen to have a photo of that radio?

The part numbers are valid. If you have a factory diff lock than 2 separate part numbers are needed, 90366-75001 Driver Side & 90366-50007 Passenger Side, no diff lock than 2x 90366-50007.

What is your VIN?

I am employed by Toyota/Lexus Corp. Work at a local dealership in San Diego, Calif in the parts dept. I work all 3 counters; wholesale parts, retail parts, and the technician counter. :) 25 years now. I get to do a lot of research on my runner, and discounts are very nice. $80K a year, wife...

Any update as to when this part will be available again. I am late to the party, just found this link. I need 3.

Big Bear Trail Ride Aug 27, 28, 29 It has been a while since I have seen a local trail ride for Big Bear and I have not seen the dirt in almost a year. So I thought I would get a few people together for a low key fun ride. The details are - Fri (Aug 27) morning meet up with several members...

UPDATE*** Took the factory radio head unit to a factory radio service shop. The microprocessor and power supply were both dead. The technician stated "somewhere along the install of the new headlights you caused a short which produced a power surge that went into the constant low voltage power...

I have a Shrockworks and am running a Warn M8000. Relocated the box to the engine bay and made all new power cables. Installed wireless controller as well.

Factory radio. This weekend I will be removing the radio to see if power is at the connector to the radio. Perhaps there is a 10 amp fuse that plugs into the back of the radio like aftermarket radios use.

97' & 98' do not have a radio relay.