Recent content by Travisstorma

I know this is old... but THANK YOU!! for this. Been fighting this issue for years. I cut the tape holding that connector up and water dripped out. Pins were corroded. Got a new junction connector from a salvage yard and cleaned the pins with a very small file and electronic connector cleaner...

I’ve been running Kirkland synthetic at ~12,500 intervals for the last 200,000 miles. Last report showed still had plenty of life left. Sent from my iPad using Tapatalk

I drilled the factory nuts out and welded new nuts on top of the factory nuts. Sent from my iPad using Tapatalk

The spark is normal. The first spark is usually the result of the inrush current of electronics that have capacitors in them that are charging. Sent from my iPad using Tapatalk

I’ve been stuck a time or two in a different vehicles with no winch. I’ve always had the saying... I’d rather have it and not need it than need it and not have it. However I frequent bad roads several times a year. Sent from my iPad using Tapatalk

How would the computer know that the speed was incorrect? Is there any GPS input near that year? If there was a gear ratio change between factory and current several other manufacturers will post a code since the pulses per revolution doesn’t match up to the expected abs pulses. Not sure on...

Thank you so much! Sent from my iPad using Tapatalk

Hi all- Would anyone have 5th gen ground to lower fender measurements on a stock suspension no bumper 4Runner for front and back? I have a 2016 SR5 that I’ve added a Shrockworks bumper and winch to. I really wish I would of measured beforehand to see how much lower the front is riding now...

Yeap. I’ve had to drill through and weld a nut to the factory nuts on the skid plate mount due to dealer stripping them. Sent from my iPad using Tapatalk

While this probably isn't the issue, I have got calipers that had the wrong bore size. We bled and bled and bled. Finally measured the pistons between the two and there was marked difference. Did some research and found the manufacture misboxed some parts. When the correct caliper was...

I drive my 4Runner for work usually averaging 40-50k a year. I sent in an oil analysis at 12,500 and everything was above normal for the oil. Could have probably hit another 3-4K out of it with no issues. Sent from my iPhone using Tapatalk

UPS finally found my bumper when Shrockworks was getting ready to reship. Question, on 2016 4runner, what does the outside of the headlight filler trim connect to? There is a hole at the bottom that is parallel with the ground. I would think there is a bracket that is supposed to connect to one...

Not waiting on sliders, but still waiting on my bumper. UPS freight lost it and still attempting to locate..... over a month later. Getting pi$$ed is an understatement. Sent from my iPad using Tapatalk

My front bumper was supposed to be here this Wednesday. However, UPS freight seems they can't route crate correctly. Currently lost somewhere...

I use my 4Runner for field service of X-ray equipment at hospitals around the region. I drive usually 2,000 to 4,500 miles a month. I need the room for tools, test equipment and parts. I like it. It isn't loaded, but I wanted something I enjoy driving since I spend so much time in it...