Recent content by Treestand_Twerkers

gonna check this out too

yeah thanks. Next is T belt kit and I might as well replace the whole AC system while I'm in there it seems like. AC hasn't worked in the 2 yrs of ownership. Just checked High Pressure for a quick test and it seems to hold pressure. Need to check electrical, trying to find fuse/relay for it...

thanks ok, finally got replacement tranny bolt with crush washer delivered and added a little FIPG. not leaking so far since yesterday. I did take a stick magnet to get out any small pieces of metal from the threading up in the pan. when need to change again, we'll see how it goes. may have to...

Right on, I'll give it a go.

Ok. I have a tap/die set. need an extension for a tap (should get one anyways, have needed on in the past) and ran my m10x1.5 tap in there and heard minimal manipulation. I'll stick a magnet stick up in there and try to catch anything before I run some fluid down to help flush if needed. I...

upon further inspection, drain plug itself is messed up threads fubarred.. who knows what pan itself looks like.. will know more later today

Whilst changing all fluids on 2000 Limited, 3.4L, tranny plug was adequately tough to remove, and upon new oil, with new crush washer, won't tighten to spec. MAFIA says try thread tape and another new washer, other option perhaps drop pan and re-thread a larger hole. (I do have 2 front dif...

update fixed all the wires and problem solved. going to do the other truck just cuz. needed 14g, 16, 18 and 20 gauge wires. Tried the quick heat solder shrink wrap sleeves, on a couple, don't prefer them. melting before solder melting.. So, conventional soldering. TIP** I have an...

Tailgate wires broken HOpefully fixing this resolves issue. Either way, doing this fix on the other truck 2000 Limited.

Update 8 broken wires or so at the rear door. I'll update once I get those fixed. can't upload pic, must be too big.

I'll do that. what is the badluck method mentioned?

Update So. fuse number 20 is the problem. There's a short somewhere. Fuse 20, ECU-IG, 10A, Cruse control, ABS system, Elec Controll Auto Transm system, Power antenna, power window, elec moon roof, power back window, back window defogger and back window wiper I pulled a 10A from another...

could be... Could be, thanks! Mine is fried. looking to replace connector and get bulbs. Anyone know where to get a third brake light bulb connector?

Update So, looked up some of that DTC-1 diagnostic for ABS under the hood by manifold. 1) Left "in-house" jumper, connected E1 to Jc, turn to ON, no ABS light. 2) Same with "in-house" jumper removed 3) Same with both removed A) Left "in-house" jumper, measured voltage across E1 to Jc = 4.8V...

Update So I can see the solenoid working when I put 12v to it, truck running. truck running, testing for voltage to the female half of the connector. Not getting any voltage. That connector is one of two, that come from the computer that is aside the solenoid and shifter... replace computer?