Recent content by trod0

That’s what I figured, I’ll end up with top plate spacers. I was just thinking of the 16in springs on the lowest setting but it’s not worth the risk

Only reason would be is to run a full 3in up front. I believe they’re both rated at 600#.

Has anyone ran different springs with their 6112’s? The springs they come with are 14in and I have a set of 16in Toytec’s that would fit the set up. Has anyone run 16in springs with them? Would the 2in spring be to much? Any experience or info would help. Thanks

In LC as well. To bad I have a V6.

Thanks for the reply. Just placed an order for a 3rd Gen

Shipping Typically how long does it take for a customer to receive the kit? Let’s say I order today what’s the usual timeframe for someone to get it?

I’m having the same problem. When I start my vehicle the VSC/Trac light are off but as soon as I put it into reverse or drive and let my foot off the brake the lights come on. Would it be my brake light switch? Even though my brake lights work fine?

Lol must be nice, you guys are like lucky

Thanks everyone for your input. I went underneath it today and inspected it. Some of the bolts were loose and I noticed they were grade 5 bolts. They looked very similar to OEM bolts. The OEM bolts have a #11 on then. I went and got all eight bolts and replace them all and tightened them down...

Thanks. Hopefully that’s it. I’ll check them out today and Retorqued them if needed.

When I changed out the bushings I inspected where they attach to and it fine with no rot. There is no rust on the undercarriage because the vehicle is from the Southwestern desert.

I’ll check the drums tomorrow and see if that’s it.

I have a question. Has anyone else experienced their vehicle pulling to the right when pushing the gas then pulling to the left when you let go of the gas? I replaced all the rear control arm bushings with poly and still does it. I can’t seem to figure it out so I’m looking for advice. Thanks

If you don’t want to replace your cats you can do something like this. https://youtu.be/_hJSeuMmhPI

Ok I found the problem and fixed it. Due my exhaust my o2 sensors were reading bad. That causes the engine light and VSC/TRAC lights to go on. This disabled all my traction control, DAC and ATRAC. I plugged my Runner into a computer and my only codes were my o2 sensors. Since I don’t have no...