Recent content by TSheff

Nothing to grab. I ended up drilling and grinding the stud and remaining nut bottom, until I was able to remove the wheel. Wheel is slight ly damaged but that was the only way I could get into the recess below the face of the wheel. Wheel off and new stud installed, I'll buff and brush all the...

10/2/2023 Again this is an old thread and about studs breaking, that would be simple. Here's what just happened to me and I need suggestions. Was trying to remove the front right wheel to replace control arm bushings, pretty routine stuff. I did the left side yesterday. I noticed all the lugs...

I need both sides - flare extensions and running board ends (front). If I had to guess I would suspect the previous owner tried to run tires that were too large and ruined them, so they were removed.

Not sure I have enough post for pictures. Won't let me upload pics. OK I think it posted.

Posting here on an old thread, because I don't have enough post to start a thread. I have a 2000 SR5 and am looking for the bottom front fender flare section as well as the front tip for the running boards for both sides. I thik the previous owner was probably running tires that were too large...

Thank You. When I first read the trhead it only showed the old stuff and would not page forward. On the next visit I clearly saw it ws quite active. Coming from the HD Forum it is common for people to respond as if they are helping the OP, when in reality the thread had been dormant for years...

Call it a Bump or just reviving a 13 year old thread but here goes. I've read the original information here and appreciate the effort by those who are here to help. My question is since the original postings has any technology or any options changed? Leaning toward OME springs 2.5" and Bilstien...