Recent content by turbohardtop

looking for additional review on this rack. I do like the fact that it is lighter but wondering how it handles loads comparing to the one from SSO that has thicker bars and thicker aluminum sides. .

Thanks for the info everyone. I will give Sean at Landcruiser Specialist and go from there.

I hope this is the right forum for this question but is there a shop that you guys would recommend for BMC work in North Austin/Cedar Park area? Thanks in advance.

Here it is a little zoomed out Sent from my SM-N950U using Tapatalk

This is the lower hose of the two that is connected to the front piston. Thanks.

I was in a hurry to cut off the tab near the KDSS system when I accidentally damage the hose. Well, it busted today while driving. Is there a non-toyota/Lexus place that would fill and bleed the KDSS system after getting the hose replaced? This is on a GX460 which is similar to the KDSS...

Doe anyone know the spare tire storage area of the 4runner comparing to the GX460? I was told that 285/70-17 wont fit on the GX. I will be running 285/70-17 KO2's on the GX.

What is the verdict on the best way to install UCA, front and rear shocks for cars with KDSS system. I have seen some that remove the KDSS sway bar to nothing remove at all except UCA bolt. Could someone confirm if you put the car in 4Lo then the KDSS is disengage. This would allow for...

Thank you Codeman for the picture. I do have that same bracket. Do you have KDSS on your 4Runner? Is the mount location same on both sides? Do you have any rub issues?

I am getting ready to install my Radflo coilovers with adjustable reservoirs on my GX460. I believe these kits come with the same mounting brackets for the latest generation 4Runner. Does any one have pictures of your mounting location for the reservoir that does not rub. Thanks.

saved me 100 bucks on a TC UCA.

For those that have installed the Radflo coilver front and rear shocks, how do you like it so far. How do you compensate for KDSS lean? Where have you mounted the reservoir? Thanks in advance.

Does after market coilover system come with 10mm taller springs on the driver side for KDSS systems? I believe the springs on the KDSS equiped vehicles are taller by 10mm.

I am getting some Radflo with external reservoirs and wonder if you guys have some pictures of the mounted reservoir on the wheel well? Thanks.

ok, so the cambolt are the ones with the markings on it for alignment correct. Thanks again.