Recent content by tylertenny

I believe 25702-31014 is the correct part number since it's for the left side. I never did order the new part. I ended up just clearing my code after it happened and, luckily, it never came back.

I ended up pulling the trigger on a set of P rated Razr 285's from Simple Tire. I was going back and forth between these and C load KO3's but for $710.51 shipped I figured I would roll the dice!

I replaced my front pads and rotors over the weekend. While I was working on that I noticed that both front Eibach shocks are leaking so I suppose I'll have to take care of that next. <a href="https://ibb.co/sRskwKg"><img src="https://i.ibb.co/vqLgP3c/PXL-20240929-190954362.jpg"...

I moved to a house with a bigger garage in May and I finally got to spend a weekend out there knocking out some of the maintenance items that have been on my to-do list. Over the weekend I changed my rear pads and rotors, changed the rear diff fluid, greased the driveshaft, changed the engine...

I'm hoping to have more garage space in the near future but, for now, I have everything I need crammed into my little 1 stall garage. <a href="https://ibb.co/0cvhzHz"><img src="https://i.ibb.co/6mLgqjq/PXL-20220918-202400579.jpg" alt="PXL-20220918-202400579" border="0"></a>

This seems to be my experience most of the times that it's happened. On the gas heading towards an intersection and, making sure nobody is right behind me, quickly moving to the brake because I don't want to blow through a red light. It's definitely a little scary and very embarrassing! I've...

On numerous occasions, when I've pressed the brake pedal firmly (not slamming on it), my brakes have locked up and my tires skid. From what I can tell, just one of the tires is leaving a skid mark (rear passenger, I believe). I would expect the ABS to work the same way it has in every vehicle...

I have the LFD 3/4 rack and it's worked very well with the Yakima Skybox 16. I've done several long distance trips over the last few years and haven't had any issues. <a href="https://ibb.co/3dNfg4Z"><img src="https://i.ibb.co/YQkDHPs/4runner1.jpg" alt="4runner1" border="0"></a> <a...

I put the factory cover back on after taking that last photo. I kept all of the old pieces in case I ever need them, too. Better safe than sorry!

Uni Filter mod <a href="https://freeimage.host/i/HoKuT4R"><img src="https://iili.io/HoKuT4R.md.jpg" alt="HoKuT4R.md.jpg" border="0"></a> <a href="https://freeimage.host/i/HoKAqF4"><img src="https://iili.io/HoKAqF4.md.jpg" alt="HoKAqF4.md.jpg" border="0"></a>

I'll likely just order the new one just to have a little more peace of mind. I do appreciate the offer, though!

My scanner showed that bank 2 was stuck closed. I found the OEM valve on eBay for $180 shipped so I think I'll pull the trigger. I did already order 2 air tube gaskets but I'm waiting for shipping confirmation. I appreciate the input and hope that the replacement install goes smooth!

I think I'll probably just order a new valve and replace it. I'm guessing that will resolve my problems and, if it doesn't, then I likely have bigger problems.

My scanner says that the valve is stuck closed. I bought the filter so I'll put that on when it shows up. I'm hoping that the code doesn't reappear but it sounds like it likely will, based on what others have experienced. I'm just hoping I don't get the additional codes along with it that put it...

I used my remote start to let my 4runner warm up a bit since temps here are in the single digits right now. I get in and see the CEL and Trac Off lights lit up. It drives just fine during my 10 minute drive home. I plugged in my scan tool and it pulls the P2443 code. I let it sit for a while and...