Recent content by uhohh

Here are some pictures of the shackles. Not an extreme difference but noticeable. A little over an inch higher on the drivers side.

I try some pictures tomorrow.

Ok. I'll give it some time. It just looks goofy for now . Thks.

Yes, there is a difference in the shackle angles. I thought it may be in the bushings or something and tried some ditch crossing at an angle hoping to "work it out", but nothing. Don't want to drive it much until the alignment is corrected. BJ spacers have got my front tires pushed out at the...

What can cause my 1987 4runner to lean to the right? Measuring from the ground up to the fender well, there is over an inch difference. Just installed new OME 2 inch lift springs in rear and bj spacers up front. I backed the tbars completely off and it is still leaning. It does have a full tank...

NEVADA... Here's a few front end pictures. Pretty new to this stuff. Not sure about a drop bracket. The torsion bars are white, making me think they are after market. Anyway, here's some pictures. If you need anymore that can help me make the right purchase let me know. Thks.

With those numbers, 66.1 on cab and a 28.3 inch tire, compared to my 75 inch cab 3 inch BL and 33 inch tires, I have about 1.5 to 2 inches of spring lift. Really looks like more. But I will probably go with that unless someone changes my mind.

Thanks for that. I'll use those measurements and see what I get. Been looking at the OME springs, but only see them in 2 inch lift. Not sure that's enough to avoid creating a low rear. Maybe I missed something on the Web site. Just trying to buy a bolt in replacement for the rear without...

I'm sure the NWOR springs are of good quality. Moving the hangers is a little more fab work than I can handle. Changing parts I can tackle, no problem. Cutting and moving them, getting everything aligned, secure and working correctly again, not so much. Where can I find a stock measurement from...

You think 4 inches? I thought 2 or 3 inches from the springs and 3 from the body lift. Here's a picture of the body lift spacer. This is the front left. I wish someone knew a stock measurement from frame to axle. Mine measures 10 3/8 from spring perch to the bump stop and 13 1/2 inches from...

My question about lift height got lost in my other thread. My 1987 4runner has NWOR rear springs for a 1989-1995? Truck which means they are too long. My shackle is buried against the frame. If I buy new springs, what lift do I need to buy? I like the ride height I have now. Tires are 33...

Yeah. Already not a fan of the thornbirds. Got the hubs swapped out, replaced both cv axles and serviced the bearings up front. Here is a picture of the 4runner. I didn't know what to put in there for comparison. I want to replace the springs and maintain the ride height. What lift do you think...

It'll take me a day or 2 for more pictures. The front is on jackstands right now until I swap out those automatic hubs. I got new ones here just no time.

New question. If I decide to buy new rear springs, I would like to keep the same ride height. Is there a measurement on the vehicle that would tell me how much suspension lift I currently have? I searched here and most suggestions were from the wheel to the fender. Some said top of wheel others...

NWOR says that is an old part # and those springs were for a 1989- 199? Truck.