Recent content by WHITE-OUT

I did remove the standard 12v and used the ARB female socket that screws in. I wish I could upload a pic from my phone but this Tapatalk is not cooperating. Basically I used the 8awg from the ARB wiring kit and ran it directly to the plug. Then I jumped off the plug to the switch, from...

Sent from my iPhone using Tapatalk

Let me start off by saying I in no way really know what I'm talking about as facts. I'm just speaking from experience I have seen. 1) I don't think the voltage is as important as the amps being pushed. 2)To clarify what I was seeing was that after a three + hour ride home I connected the...

I really don't have a clue but I completely unplug it to be safe. I read it in the manual. "It is absolutely necessary to disconnect the cooler from the battery when a High-rate charger is being used." https://www.manualslib.com/manual/1085513/Ezetil-Ezc-25.html?page=8#manual

My 2 Cent: Our alternator as it was explained to me is not going to provide your deep cycle battery with enough AMPs, or voltage to fully charge. The computer only senses the voltage available. I can't remember the specifics but if your computer senses that your battery is at 12+ volts it...

Steel

I shouldn't have trusted my two spotters! I knew it when I pulled up to the ledge I was lined up wrong, but went for it anyways.

Pretty sure this is when my skids got bent... <iframe width="560" height="315" src="https://www.youtube.com/embed/N9IMewyhQGY" frameborder="0" allowfullscreen></iframe>

I was actually able to get the transfer skid plate out and that allowed enough room to get between the skid and cross member to cut the bolt. These are supposed to the flat...

Anyone have an issue with removing the RCI transmission skid plate? Seems after a couple big hits to the plate I have broken the weld nuts inside the cross member and now can't get the plate off. There is very limited access inside the cross member to grab the now spinning weld nut. I would...

To tell the truth I only want the body lift so my wife can use the sliders more like a step. I could possibly go with a 1/2" or 3/4" lift and be good.

I did some searching but couldn't find anything. I currently have a SSO hybrid front bumper and I would like to put a 1" body lift on my truck. My concern is if the body lift will then create a gap between the plastic bumper and hybrid. If you have installed your SSO bumper and then put a...

Seems like no one really has a clue on what the ride might me like with this hybrid set-up with a suspension on the rear and a lift in the front. I guess we will see in a couple weeks when I put it to the test. I can't stop myself from putting new hardware on the truck if I have it all...

I'm in the process of upgrading my suspension and want to get some opinion. I little back ground 2014 SR5 P w/ Third row Toytec 2.5" spacer lift Upgraded Bilstein PTR13-35101 on the rear Bilstein PTR13-35100 on the front Gobi Stealth Full RCI skid plates White-Knuckle Off Road DOM Plated...