Recent content by wicket27

Built a high clearance bumper for my 03, was scraping the oem one a bit. Need to take some updated photos with supports and larger tires. No plans for a winch and wanted something light while keeping a semi stock look in the front

Is the 1 wheel still availible?

If they are still available Im interested in the set of ET lug nuts and 1 spare

I think it would be smartest to go with lc100 inner tie rods, and from my understanding they will fit on the 4th gen rack. But I'm with aemravan here in that only upgrading the outer tie rods is pretty much a moot point. Shoot me a dm if you want them otherwise Ill keep them around for some...

I have a set of 100 series tie rod ends and a spare 4th gen rack I wanted to rebuild and install them on. I have some more pressing issues and would be happy to send the ends to you for just cost of shipping.

Hi All, Will snag a couple pics later and add them to the thread, but swapped my LCA's as the ball joints and bushings had gone bad. I also have 2 sets of cam bolts, one is the used oem that needs cleaning and another set is new from SPC. I figured someone can make their choice of bushings and...

Not sure what tire size you are running, but if you are at 285 or 315s then that much caster is usually used to make clearance easier. Only issue I would imagine is that steering is gonna be tougher than it needs to be

still for sale?

Adding a testament, thought I had an exhaust leak but this fix ended all the tippy tappy noises. This was on a 2003 v6 with 220k miles

Resurrecting this one. Need to clean up the edges a little more and spray under where the fender liners were.

Limited Running Boards for pickup Whats up! took my running boards off my 03 limited while waiting for my rock sliders to be ready. They are in the kinda off gold color and have puddle lights. Free for pickup in santa cruz, CA!

Forgot to update but ended up taking the knuckle off. Used a slide hammer and the bearing separated? Inner section holding the little cylinder bearings was stuck in the knuckle and no amount of heat/beating I could do would get it unstuck. Machine shop pressed it out without too much problem...

Hello all! Replacing my wheel hub assemblies as my front wheel bearings both were in need of swapping. Got the drivers side one done with minimal hiccups. Passenger side is really giving me a run for my money. Will post pics in a little when I get off work, but I cant seem to get the base of...

Grabbed a 03-05 one, couldnt find any photos of one installed. Ill have to take some of my own when it comes in.

Ive got a tan rear cargo cover and some side steps off a limited with the puddle lights. Located in Santa Cruz, CA if anyone is interested