Recent content by wvanstone

Update Hello Everyone!! its been a long time since I was on the forum. I work full time, I am going to school at night and run a photography business (William Van Stone Photography) on the weekends. Anyway I just wanted to give everyone an update on my heated seats. I use them almost...

Just bumping it, though maybe since it's getting colder a few guys might need the info.

Yes please keep us updated. What is the model number? On the website I only seen the 4runner up to 2009?

Is it possible just to take one seat out and still leave the covering material in place for that one seat? I would like to remove one sear and replace it with a security box or shelf.

Yes, where did it go?

No way. A refrigerator draws way too many amps. at best the inverter in your truck can put out 400 Watts which is 3.33 Amps (ohm's law) Power / Volts = Amps 400W / 120 volts = 3.33 Amps The average fridge draws at least 10 amps or more.

getting linked Is this mod worthy of getting linked to the "Modifications, Write-Ups, & Quick Links" section? How do I go about submitting it? I did PM Jessy1983 but didn't hear anything back.

Dam It! I knew I should have waited for the 2012 "end of the world" 4 runner special edition. hummm.. i wonder what it would have for standard features?

Still looking to buy Still looking to buy please PM me is you want to sell their black divider / separator that is located in the center console of the 2010/2011 4Runner

Still looking to buy Still looking to buy Please PM me if you want to sell

Part 5 (sub-controller final location) Part 5 (sub-controller final location) Ok the last step is to place the sub-controller under the seat. This picture comes from nashman69g, (thank you) it's a picture of the sub-controller under the driver's seat. The second picture is of the connector I...

Part 4(b) SR5 harness layout and install Ok, if you own a SR5 you will need to take the 82223-35060 wire harness and cut all 6 wires for the LH switch and all 6 wires for the RH switch and use them (the connectors and attached wires) to make up a harness. When you cut the wires make sure you...

Part 4(a) Trail harness setup Ok if you own a Trail you can use the whole wire harness - 82223-35060. You will still need to cut 4 wires on this harness. It seems like the Trail has a base harness system that is closer to the Limited than to the SR5. I own an SR5 and had to cut all 12 wires...

Parts 4 & 5 will be tmro night.

16 is the correct number if you want to do both seats. One sub-controller will take 8. Yea the price of these things just SUCKS!!! Remember I took a big chance buying all this stuff hoping I could get it to work. At first I only got enough parts to do one side. your lucky! before you found...