Recent content by yoyoyotrevo

Hey, easy guys...I work at autozone. You might also check the needle bearing that the axle goes into on the drivers side of the differential. Mine has gone bad and started out as just a clicking while taking left turns and has gotten progressively worse and rattles over every bump now. You can...

Are you referring to the little black socket that snaps in on top? If so, I've been through that plenty and I used to just JB weld the dickens out of it and didnt have any problems. Just tonight actually, I was working on my new retrofit and my new housings were missing that little piece. I...

This is part of the reason I like to wire my own relays, so I know exactly whats going on. Although, after two years, it gets a little confusing when everything was ran with black wires. Thats good to know. I'll proably be doing this next time just to save some money on the copper stuff.

Oh I know youre lightyears ahead of me on electrical things which is why I pulled it. I reconnected everything and all is good now. Honestly I think I had the relay connected differently previously(I'm not positive but something seemed different when I hooked it back up), but I would have never...

I pulled the relay completely the other morning and amazingly the headlights have been working normally. I guess my question is what could have caused it? That relay has been in place for a couple of years and I havent had a problem until I used the hot wire from the fog lights to trigger it...

Tonight, I switched my spot lights in my bumper out with some HID converted PIAA 510 fogs that will actually be useful on the road. After about 4 hours of breaking more than I fixed, I finally managed to get the project all buttoned up. Go to check out the lights and one of the fog lights isnt...

Buummmpppp... someone make me an offer on these shocks. Great, affordable shocks for that new lift your piecing together!

Just curious, why do you say the Tacoma 5100 is junk? Whats the big difference?

Nahh, 3mm or 8mm, its still 90 degrees of sexiness to me. Its other curves more than make up for it.

Sure, count me in for a drop bracket as well. Just let me know what you need!

Or you could just try to JB Weld it until a decent one can get there.

I PM'd but im definitely in for one as well. I'll send my shipping address.

Do you have poly bushings? I replaced literally everything trying to track down a ticking sound when hitting bumps or rocking side to side. Finally sprayed all the bushings with dry lube and that did it. Worth a shot.

Count me in if the cost isn't too crazy.

Been dealing with the same thing on mine for months now. It gets a little annoying when every time you turn right water droplets sprinkle on your forehead. I haven't found time to mess with it yet, but I'm just going to smudge a little black rtv silicone in there on top and bottom of the crack...