Aisin hub cone washers and studs....are they all the same?

[jcramsey]

I've got a 2000 4Runner with a manual hub conversion using parts from a 1st gen Tacoma. Previous owner had no cone washers or nuts holding the hubs on. I see plenty of companies that carry the studs and hardware for the Aisin hubs, but they all say they're for 86-95 Toyota trucks or Landcruisers. Customer support for the ones below could only confirm they were for Landcruiser. I'm assuming they're all the same, but wanted to check with the masses first.


Front Axle AISIN Hub/Drive Flange Stud Kit - Fits 1958-1/1998 40/55/6062/80 Front & Full-Float Rear Axles

 

[sleepydad]

I've got a 2000 4Runner with a manual hub conversion using parts from a 1st gen Tacoma. Previous owner had no cone washers or nuts holding the hubs on. I see plenty of companies that carry the studs and hardware for the Aisin hubs, but they all say they're for 86-95 Toyota trucks or Landcruisers. Customer support for the ones below could only confirm they were for Landcruiser. I'm assuming they're all the same, but wanted to check with the masses first.


Front Axle AISIN Hub/Drive Flange Stud Kit - Fits 1958-1/1998 40/55/6062/80 Front & Full-Float Rear Axles

I just started a rear full floating conversion... and I wondered the same thing about the cone washers.

I have never ordered the land cruiser ones but I can confirm the 1st gen taco free wheel hubs are the same as both the 1980's solid front axle and IFS front axle pickup and 4runners.

I can't imagine they would be different. that's a pretty amazing price for that hardware... I might be a little skeptical on the quality given the low price... I don't know never have ordered from them?

I know the hardware cost can get surprisingly sharp quickly on the manual hub stuff...

<a href="https://imgur.com/xb2dJqY"><img src="https://i.imgur.com/xb2dJqYl.jpg" title="source: imgur.com" /></a>

<a href="https://imgur.com/ZRdbWXq"><img src="https://i.imgur.com/ZRdbWXql.jpg" title="source: imgur.com" /></a>

 

[jcramsey]

I just started a rear full floating conversion... and I wondered the same thing about the cone washers.

I have never ordered the land cruiser ones but I can confirm the 1st gen taco free wheel hubs are the same as both the 1980's solid front axle and IFS front axle pickup and 4runners.

I can't imagine they would be different. that's a pretty amazing price for that hardware... I might be a little skeptical on the quality given the low price... I don't know never have ordered from them?

I know the hardware cost can get surprisingly sharp quickly on the manual hub stuff...

Thanks. Yea the price seems a little too good to be true considering the 8mm cone washers from Toyota are like $5 apiece.

 

[jcramsey]

One more bump to see if anybody can confirm that these are the same across the board before I go ahead and buy some.

Thanks!

 

[Condernr]

Yes, they are the same.

 

[jcramsey]

Yes, they are the same.

Thanks!