CBI rear bumper install question

[cobblecrazy]

Ordered my CBI off-road fab rear bumper a few weeks ago - dual swing outs - for my 2016 TE4R. Their install PDF is a okay but I was looking for a thread that might have some more pics and commentary. One thing of interest to me was the cut line around the corner, under the taillight and where it transfers to the piece running across the back. I tried doing a search in the threads but came up empty handed.

 

[LawnDart]

Ordered my CBI off-road fab rear bumper a few weeks ago - dual swing outs - for my 2016 TE4R. Their install PDF is a okay but I was looking for a thread that might have some more pics and commentary. One thing of interest to me was the cut line around the corner, under the taillight and where it transfers to the piece running across the back. I tried doing a search in the threads but came up empty handed.

I can grab you photos of mine tomorrow.

 

[Jeremy556]

http://www.toyota-4runner.org/5th-gen-t4rs/164821-5th-gen-4runner-rear-bumper.html
http://www.toyota-4runner.org/5th-gen-t4rs/154060-5th-gen-rear-production-bumper.html

 

[cobblecrazy]

I can grab you photos of mine tomorrow.

Thanks. I was just up in your area visiting family, and I would have liked to have seen yours in person.

 

[LawnDart]

Thanks. I was just up in your area visiting family, and I would have liked to have seen yours in person.

No worries, I'll take some photos of the curves of how the bumper must be cut.

 

[cobblecrazy]

The CBI bumper has arrived!!! I checked out the link that was forwarded to me and the photos/description of the cut locations will help. Next question, in that post he did not get the swing outs/tire carrier/table, and the CBI website only describes installation for the bumper. Although it seems fairly straight forward I was wondering if anyone had pics/descriptions on the install of the swing outs. I did the dual swing out with the dual can holder and the drop down table behind the tire carrier.

 

[jbstrd]

The CBI bumper has arrived!!! I checked out the link that was forwarded to me and the photos/description of the cut locations will help. Next question, in that post he did not get the swing outs/tire carrier/table, and the CBI website only describes installation for the bumper. Although it seems fairly straight forward I was wondering if anyone had pics/descriptions on the install of the swing outs. I did the dual swing out with the dual can holder and the drop down table behind the tire carrier.

It is as easy as it sounds. Put the swing outs on their designated spindles by using a rubber mallet. Make sure they are fully seated and install the top plates. There should be pre-Tapped holes for the latch systems.

 

[funshot]

The CBI bumper has arrived!!! I checked out the link that was forwarded to me and the photos/description of the cut locations will help. Next question, in that post he did not get the swing outs/tire carrier/table, and the CBI website only describes installation for the bumper. Although it seems fairly straight forward I was wondering if anyone had pics/descriptions on the install of the swing outs. I did the dual swing out with the dual can holder and the drop down table behind the tire carrier.

Please feel free to have a thread documenting how you wind up installing them! :tongue1: Mine comes in a few weeks and I would like to see it before I have to hammer/cut :wave:

Good Luck and enjoy your bumper!