e34Croak
New member
Haha nice. Where do you work in the Euge?
Couple Pics......OME 861 with 35's
- Thread starter GX4SEVEND
- Start date
Haha nice. Where do you work in the Euge?
e34Croak
New member
Sweet. We should meet up so I can check out your truck and figure out how to get this skank on 35's. My brotha Downpour has been helping me start to compile what I need but he now lives in AZ.
GX4SEVEND
New member
LOL thats your brother huh? Small world. We found out we went to the same high school together, just 4 years apart though. PM me your info. Stop by when ever and check it out.
e34Croak
New member
Haha hes my best friend since we we're like 12.
SPRAGUE!! haha
Antpwr
New member
ok first off WOW freakin awesome man, i love it. Now time to pick your brain a little bit, i am doing 861's with trim packers out back, top outs and toytec 3" springs up front, everyone i talk to says i have to have a 1.5" BL or do some tubing in the front in order to fit the 35's. What i want to know is did you do any of that at all, tub or trim anything or BL at all. Plus did you run a diff drop spacer upfront. Or are you just really running the suspension setup you have and thats it, and i know that the 96-02 body is supposed to be the same, but i am wondering if there are any slight differences in the body between your 97 and my 99 limited. Well ok i think i have bothered you enough, but again man, it is freaking awesome, that stance says it all, well done.
GX4SEVEND
New member
It's currently just all suspension. I had the 10mm rear trim packers from the previous 891's I was running so I kept those in there and I'm running them with the 861's. The fronts are 882's with top outs. I think it sits nicely but the ride up front isnt the greatest. I may look into coilovers upfront at some point but not sure. For clearancing up front I hammered the pinch weld completely flat, trim the bumper and that was it. I don't have flares so I didn't need to worry about that. You'll need spacers to clear the UCA but it rubs frame at full lock no matter what.
I haven't wheeled it very hard so you might want to check out the last few pages of brian2sun's build thread for clearance ideas or Dirtco's thread. You don't "need" a body lift but I bought a 1" that I'm waiting to install.
Hope this helps.
I haven't wheeled it very hard so you might want to check out the last few pages of brian2sun's build thread for clearance ideas or Dirtco's thread. You don't "need" a body lift but I bought a 1" that I'm waiting to install.
Hope this helps.
