Grinding Noise, Need Help!!

TrueBlue

TrueBlue

New member
Hey guys, just recently I replaced a bad wheel bearing in the front. I thought that it had been the cause of a grinding noise I've been getting after I let off the gas and go through corners, but since replacing the wheel bearings the noise persists. I also replaced the brake lines with stainless ones and reshimmed all the brackets so they're all in their place again.. Its not really hard grinding more like metal scraping other metal. Any ideas as to what it could be are appreciated.


Sent from my iPhone using Tapatalk
 
Register to hide this ad
Jack that side up and spin the tire by hand. That's how I diagnosed my noise, CV shaft dust shield contacting the steering knuckle.
 
jfry008 said:
Jack that side up and spin the tire by hand. That's how I diagnosed my noise, CV shaft dust shield contacting the steering knuckle.
Click to expand...



I'm going to jack it up and look at it just wanted some ideas of what to look/listen for when I do


Sent from my iPhone using Tapatalk
 
[MENTION=125581]TrueBlue[/MENTION]
Please keep us posted.
I too have a grinding, drone sound, vibration.
Mine is when the steering wheel is slightly turned to the right...think correcting for the crown of the freeway....at speed(60+ mph).
About ready to replace bearings and cv's. And while I am in there may as well do the 5th gen brake mod/upgrade.
 
DMX512 said:
[MENTION=125581]TrueBlue[/MENTION]

Please keep us posted.

I too have a grinding, drone sound, vibration.

Mine is when the steering wheel is slightly turned to the right...think correcting for the crown of the freeway....at speed(60+ mph).

About ready to replace bearings and cv's. And while I am in there may as well do the 5th gen brake mod/upgrade.
Click to expand...



Found my answer to it I think.. the cv I bought from Oreillys has a built in knuckle seal so that seal contacted the new knuckle seal I had to put in


Sent from my iPhone using Tapatalk
 
TrueBlue said:
Found my answer to it I think.. the cv I bought from Oreillys has a built in knuckle seal so that seal contacted the new knuckle seal I had to put in


Sent from my iPhone using Tapatalk
Click to expand...

That's why you don't buy O'Reilly's CVs. OEM only on stuff like that.
 
Plan A

Thought on this plan..
NEW Napa cv's, hoping that my current cv's are 2007 OEM.
Re-boot / grease current cv's, if they are, in fact, 2007OEM.
 
DMX512 said:
[MENTION=125581]TrueBlue[/MENTION]
Please keep us posted.
I too have a grinding, drone sound, vibration.
Mine is when the steering wheel is slightly turned to the right...think correcting for the crown of the freeway....at speed(60+ mph).
About ready to replace bearings and cv's. And while I am in there may as well do the 5th gen brake mod/upgrade.
Click to expand...

Could be a wheel bearing or driver's side needle bearing.
Does your sound go away when engaging 4wd?

Bad bearing or Diff noise? Please help!!! - Page 2 - Toyota 120 Platforms Forum
 
You must log in or register to reply here.

Members online

Total: 286 (members: 2, guests: 284)

Forum statistics

Threads
278,309
Messages
3,554,063
Members
248,016
Latest member
Advally Service

Share this page

Trending content

Back
Top