Moonroof disassembly / adjustment in FSM

[eurasiaoverland]

My 1996 3rd Gen has been sitting outdoors for almost two years and a previously operative moonroof is not seized (and leaking). The leak has been addressed but I am still tackling the seized drive cables.

I've removed the head lining and have the moonroof assembly out on the bench, but it's not clear to me how to dismantle and then set the position of the cables and motor once they have been cleaned / replaced.

Would anyone be able to post a few sides of the FSM, I've never managed to find on for the vehicle (always used Tacoma / T100 FSMs but they didn't have a moonroof). I think it's pages BO-54 to BO-58 approximately.

Thanks

EO

 

[Malcolm99]

These links should help, not sure about some of the YT techniques but gives you a few ideas.

1996 4Runner sunroof fix - YouTube

http://www.teamtoyota4x4.org/archiv...pdf/02rmsour/2002/024runne/bo/sliroo/disa.pdf

http://www.teamtoyota4x4.org/archiv...pdf/02rmsour/2002/024runne/bo/sliroo/adju.pdf

 

[eurasiaoverland]

These links should help, not sure about some of the YT techniques but gives you a few ideas.

1996 4Runner sunroof fix - YouTube

http://www.teamtoyota4x4.org/archiv...pdf/02rmsour/2002/024runne/bo/sliroo/disa.pdf

http://www.teamtoyota4x4.org/archiv...pdf/02rmsour/2002/024runne/bo/sliroo/adju.pdf

Thanks, the pdfs are helpful. I saw some pages from the 3rd Gen FSM here: Write-up for the moon roof/sunroof motor replacement

But it skips the adjustment procedure.

I still think there is some adjustment with the marks on the tops of the sliding rails, and the mark mentioned on the moonroof motor.

 

[Malcolm99]

BO-62 describes that, diagram N11160.