New member with a 4th gen!

[t4r98tacoma]

New 4runner owner, but not new to Toyotas. my 4runner is a V8 full time 4wd
Has some nifty buttons I don't know what they really do as far as the center diff button and traction Control?

This is my daily driver! just put these 315s on there than I was planning on Putting on the 4runner but I think it's a little big so now they are for sale
And also I'd like a a few opinions and a full 3 inch lift or little lower that won't kill the cv's or hurt my diff cause of full time 4wd
Thanks guys !

 

[t4r98tacoma]

Oh and also om located on San Antonio, TX so if any of y'all are from here say what's up!

 

[Speedy Gomez]

:welcome: to T4R.ORG!

 

[Tayzorz]

Welcome! nice looking sport edition.

 

[gaterose]

Welcome to the forum, nice taco!

Check out the suspension FAQ sticky in the 4th gen subsection. Most information about lifts are contained there. 315s are a little extreme to start off with but they will fit with proper lift and massaging.

Most people tend to run 285s on the full 3" and some use .5-1.5" body lifts to make room during flexing and turning. Most people don't worry with the dif drop since the factory angle is negative or close to negative. There is a 1" drop kit available for like $50 though.

 

[momo.75]

Welcome to T4R.ORG!......:hello: